Note: Before proceeding with this installation, the display stand should be
fully-assembled on the table. The shroud works with one 37”-63” monitor.
1/4-20 x 15mm
JC bolts
(4 required)
Back
panel
0116554R2 Page 1 of 5
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Display Shroud
for InVision Display Stand
95532
1. Remove monitor mount
If the monitor mount is installed, it will need to be removed from the
display stand before installing the shroud.
1.
To remove the monitor mount, first remove the (4) 1/4-20 x 15mm
JC bolts and back panel.
Figure 1A
.
(2) 0116551
Shroud
(10) 026059
1/4” Washer
(10) 034195
1/4-20 Wing nut
(4) 0106417
1/4-20 x 1/2”
Carriage bolt
Monitor mount
Figure 1A
Display stand
4mm Hex
wrench
Tools Required
7/16” or
adjustable
wrench
(1) 0116552
Shroud base plate
