Top
Spa XS
User’s Guide
Installation of electrics:
TopSpa XS requires a 230V, 1x16A connection with a 2.5mm
2
wire cross section via a
main breaker switch. A residual current device must be engaged. It’s recommended that a timer (clock) with
an on/off switch be installed to ensure that the filtration systems runs about 4-6 hours per day. E.g. 2 x 2
hours, or 3 x 2 hours, depending on what is most appropriate for the user.
Start for instance, with the time
you usually bathe . For example 3 x 2 hours:
On 18.00 - Off 20.00
On 02.00 - Off 04.00
On 10.00 - Off 12.00
Meanwhile, the electrical heater also turns on if the temperature drops below the set value.
NOTE!
Timer
may not be installed on the incoming phase ahead of the safety switch. See wiring diagram for the correct
setup. It’s important that a qualified professional check that everything works before the bath is used. It is
therefore practical to fill the bath as shown on page 6, and that the startup is done according to the
instructions on page 7. See page 11 for suitable foundations.
WARNING!
A.
Make sure that the product is not damaged in transit during unpacking.
B.
The electrical installation should only be done by qualified persons.
C.
Read instructions carefully before installation begins.
D.
We are not responsible for product malfunction or damage if the instructions are not followed during
installation.
E.
Do not connect power before the installation is complete.
F.
NOTE!
If the hot tub is built into a terrace or similar, the construction shall be built in such a way that
all sides are freely accessible for servicing. Outer paneling and eventual insulation must be easily
removable
G.
Read the technical instructions before installing the bath
H.
Read the users instructions before using the bath
I.
Do not leave children in the bath without supervision
J.
Do not sit with your back or head against the skimmer
K.
If automatic dispensers (floating, etc.) are used, careful adjustment should be made to avoid incorrect
dosage. Follow the recommendations in our instructions.
L.
The circulation pump also generates heat and if it is running a long time it can raise the temperature by
several degrees in one day when the tub is well insulated.
M.
Check the quality of the water, as well as temperature and function, regularly, don't leave the spa
unmonitored for long time periods.
N.
If the water's drained and the bath isn't in use during cold weather, then all screw connections are to
be left open so that any water can drain out. Drain the bubble system using the blower.
O.
When filling water and the temperature is below freezing, the pumps and pipes are also cold. Take this
into account and fill with warm water first, or warm up the space with an appropriate fan heater
before filling with water.
P.
A frost guard can be placed in the technical area to protect against damage from freezing in cold
weather if the equipment fails.
2017-05-30
1
