Portable CD Player
SMD-144
Instruction Manual
1
PLEASE READ THE INSTRUCTION CAREFULLY BEFORE OPERATING THIS UNIT.
WARNING
To prevent
re or shock hazard, do not expose this CD player to rain or moisture.
IMPORTANT
Since the CD circuitry may cause interference to other radio tuners nearby, switch this unit off
when not in use or move it away from the affected radio tuner. This device complies with Part 15
of the FCC Rules, operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesirable operation.
Caution: Changes or modi
cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE : This CD player has been tested
and found to comply within the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This CD player generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this CD player does cause harmful interference to radio or television reception, which
can be determined by turning the CD player off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the CD player and receiver.
• Connect the CD player into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio / TV technician for help.
SAFETY CERTIFICATION
This Compact Disc Player is made and tested to meet safety standards of the FCC, requirements
and compliance with safety performance of the U.S. Department of Health and Human Services,
and also with FDA Radiation Performance Standards 21 CFR Subchapter J.
DANGER
LASER SAFETY
This unit employs an optical laser beam system in the CD mechanism designed
with built -in safeguards. Do not attempt to disassemble. Refer to quali
ed
service personnel. Exposure to this invisible laser light beam may be harmful to
the human eye. THIS IS A CLASS-1 LASER PRODUCT. USE OF CONTROLS
OR ADJUSTMENTS OR PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS LASER LIGHT BEAM EXPOSURE.
SAFETY PRECAUTIONS
1. Do not open the cabinet. Refer servicing to quali
ed personnel only.
2. Do not expose to excessive heat, direct sunlight, dust, moisture, vibration or shock.
3. Use ONLY the AC adapter required, others may damage your unit. Disconnect from the wall
outlet when the CD player is not to be used for an extended period of time.
4. When cleaning your unit, use a soft dry cloth, do not use solvents or commercially available
cleaners as they may damage or discolor the
nish.
5. Do not wear headphones while operating a motor vehicle.
6. The headphones supplied with your unit provide superior stereo listening while allowing you to
hear outside sounds when listening at normal volume levels.
7. If you notice that the sound has become weak or distorted, it is an indication that your batteries
are low. Replace with new batteries
I N V I S I B L E L A S E R
RADIATION. WHEN OPEN
AND INTER- LOCK FAILED
OR DEFEATED. AVOID
DIRECT EXPOSURE TO
LASER BEAM.
LOCATION OF CONTROLS
1. LCD Display
2. Program Button
3. Mode Button
4. Skip Forward Button
5. Play/Pause/Power On Button
6. Stop/Power Off Button
7. Skip Backward Button
8. Battery Door
9. Headphone Jack
10. Volume Control
11. CD Door Open Switch
12. Bass Boost Switch
13. Hold Switch
14. DC Input Jack
2
POWER SOURES NORMAL BATTERIES / AC ADAPTER
Battery Power Operation
1. Open the battery compartment cover
and insert two “AA” alkaline batteries
inside the battery compartment. Follow
the polarity as indicated in the battery
compartment.
2. Close the battery compartment cover.
Note :
- Do not attempt to recharge, short-circuit,
disassemble, heat or throw the batteries
into
re.
- Do not mix batteries types. (e.g. alkaline
with zinc carbonate).
- When inserting new batteries, replace all
at the same time. Do not mix old and new
batteries.
- Weak batteries can leak and severely
damage the CD player.
- Dispose of batteries according to local
environmental laws.
AC Operation (AC Adapter not included)
1. Use only with a 6V AC adapter required
and make sure the local voltage
corresponds to the adapter’s required
AC input voltage. Insert the DC plug, at
the end of the AC adapter cord into the
DC input jack.
2. Plug the AC adapter into AC power outlet socket.
Note:
If the AC plug of this unit does not
t in your AC outlet, a plug adapter
(not supplied) should be used. Consult your local dealer on the type of plug
adapter required.
LOW BATTERY ALERT
When the battery indicator appears in the LCD
panel, it means that the batteries are losing
their charge. In this case the CD player will
not function properly and the batteries must
be replaced.
3
Average Playing Time
(Continuous Play)
Battery Type Normal Play Mode
Alkaline “AA”
Ni-CAD
Rechargeable
(min speci
cation
recommended
1.2V - 650mA)
Note: Zinc/Carbon, or Zinc Chloride type
batteries are not recommended for this
unit as their use will result in extremely
short playing times.
Approx 9 hrs.
Approx. 3.5 hrs.
LISTENING WITH EARPHONES
Connect the plug of the stereo headphones
into the PHONES (GREEN) jack.
Caution:
Avoid excessive volume levels
while listening to sound for a long period
of time when using earphones.
Adjust Volume to the desired level.
HANDLING COMPACT DISCS
This unit is designed to play only compact discs bearing the identi
cation
logo below. Other discs may not conform to the CD standard and may
not play properly.
• Dirty, scratched or warped discs may
cause skipping.
• Handle the disc only by the edges. To
keep clean, do not touch its surface.
• Discs should be stored in their cases
after use to avoid serious scratches.
• Do not expose disc to direct sunlight,
high humidity, high temperatures, dust,
etc. Pro-longed exposure to extreme
temperatures can warp the disc.
• Do not stick or write anything on either side of disc. Sharp writing
instruments or the inks used in some felt-tip pens may damage its
surface.
Remove the disc
Hold the edge and gently press the center
pivot as illustrated, to pick up the disc.
CAUTION:
Wait for the disc to stop rotating before
pressing the OPEN button.
Note:
This unit can play 3” (8cm) single
CDs without an adapter.
INSERT WITH
THE LABEL
FACING UP
PRESS THE CLAWS
AT THE CENTER OF
THE DISC CASE.
PRESS THE
DISC GENTLY
TO INSERT IT
LIFT OUT WITHOUT
TOUCHING THE
RECORDED SURFACE.
INCORRECT
CORRECT
FROM THE CENTER TO THE EDGE
INCORRECT
4
5
CLEANING DISCS
• Finger prints should be carefully wiped from
the surface of disc with a soft cloth. Unlike
conventional records, compact discs have no
grooves to collect dust and microscopic debris
so gently wiping them with a soft cloth should
remove most particles. Wipe in a straight
motion from the center to the edge.
• Never use thinner, benzine, record cleaner or anti-static spray on a
compact disc. Such chemicals can damage its plastic surface.
BASIC DISC PLAY
This CD-player can play Audio Discs including CDs, CDRs and CDR/
RWs.
1. Connect the headphones to the PHONES (GREEN) jack.
2. Press the OPEN button to open the CD compartment lid.
3. Adjust the VOLUME to minimum.
4. Insert the disc with the label side facing up.
5. Close the lid securely until a click is heard.
6. Press the
PLAY/PAUSE button to start playing.
To Emphasize the bass sound
Set the BASS BOOST switch to the ON position.
Note:
The bass boost performance will be dependant on the VOLUME
control setting.
HOLD Switch
This switch prevents accidental selection of an unwanted
function during Playback or Stop mode. In the HOLD
“ON” position, no function button on the unit can be
operated (except OPEN). Moving the switch to the
“OFF” position will allow the unit to return to normal
operation.
Turning Power on and off
This unit has no ON/OFF switch. To turn on and off, press the following
buttons.
To turn on: Press
PLAY/PAUSE (playback starts).
To turn off: Press the STOP button once to enter standby mode.
Press the STOP button twice to turn off the power.
Auto power-off function
When the unit is stopped (standby mode) for approximately 30 seconds,
the power will automatically be turned off.
CD827 SoundX SMD144.indd 1
CD827 SoundX SMD144.indd 1
2010/4/23 2:28:44 PM
2010/4/23 2:28:44 PM
