www.soundskulptor.com
Document revision 1.1 – Last modification : 21/04/08
PSL1 Assembly guide
Safety warning
THIS KIT IS NOT FOR BEGINNERS !
This kit is main powered and use potentially lethal voltages. Under no circumstance should someone undertake the
realisation of this kit unless he has full knowledge about safely handling main powered devices.
Please read the “DIY guide” before beginning.
Print or open the following documents :
•
PSL1 Schematic
•
PSL1 Components layout
•
PSL1 Parts list
•
PSL1 Setup guide
Follow this guide from item number 1 till the end, in this order. The assembly order is based on components height, from
low to high profile, in order to ease the soldering process : The component you are soldering is always taller than the
previously assembled ones and it is pressing nicely against the work area foam.
PSL1 Assembly guide
1. Diodes
Add D1 to D4, D6 to D8, D10 to D13. Use a lead forming tool to cleanly bend the leads at 0.4”
except for D11 which is bent at 0,5".
Warning
: Make sure to respect the direction of the diodes which is marked by a ring on the component
and a double line on the PCB marking.
2. Resistors
Add R1 to R9. Control the resistor values with a digital multimeter. Bend the leads at 0.4” with a lead
forming tool.
3. Leds
Add D5, D9, D14.
Bend the leads at 7mm from the body taking care of the anode position
(the longest lead).
Warning
: it is easy to bend the leads in the wrong direction !
Solder the LED so it rests on the board. Start by soldering one lead,
adjust the position, then solder the second lead.
4. Test pins
Solder the 4 test pins TP1 to TP4.
Copyright ©2008 SoundSkulptor
7.00 mm
Anode : long lead
