Quick Start Reference Sheet
Sony VPL-FE100U Series
Revision A
DR-SNY04 - 11/7/01
SP Controls reserves the right to modify specifications without notice at any time.
NOTE:
This one-page document is intended
only as a quick reference for installation
– please read the
SP Controls Application Note for a complete description of this projector driver prior to installation.
I. Driver Features
1. Input Selection Mapping
Selection 1:
VIDEO
Selection 2:
S-VIDEO
Selection 3:
INPUT A
Selection 4:
INPUT B
2. Hidden Function Mapping
Using the ON button as a shift key, press the following buttons to access the specified projector features.
Selection 1:
APA (AUTO IMAGE)
Selection 2:
ENTER
Selection 3:
ADJUST LEFT
Selection 4:
ADJUST RIGHT
Off:
MENU
Volume Up:
ADJUST UP
Volume Down:
ADJUST DOWN
3. Other Driver Features
Power Status Feedback Method
Power Current Sensor
Control Wiring
RS-232 Only
II. Wiring Specifications
NOTE: For a wiring diagram, please see the SP Controls Application Note.
RS-232:
Wire the Panel RS-232 projector port to a male DB9 as follows:
TX to
2
RX to
3
GND to
5
Connect this male DB9 to the projector port labeled
RS-232C/422A
.
BE SURE to set the hardware switch labeled
RS-232C RS-422A
(located near the com port) to
RS-232C
III. Additional Projector Information
The Sony has several configurable modes must be set at the time of installation:
•
DEVICE INDEX SWITCH
: The Panel codes assume the projector network ID to 01.
•
RS-232C/422A
: The projector control port must be set to
RS-232C
.
•
SIGNAL SELECT
: Signal type for inputs A, B, and C must be specified on the on-screen menus.
•
POWER SAVING
: The Sony
Power Saving
feature will automatically shut the projector off after ten
minutes if it does not receive a valid input signal. You should disable this option in the onscreen
menus – especially if the installation does not include a power current sensor.
•
PROJECTOR BAUD RATE
: The Panel assumes the projector BAUD rate is set to 38,400 (factory
default).
For instructions on configuring these settings appropriately, see Section III, Special Control Note in the
Application Note below.
