WM-4000D Wireless Microphone Set (Quick Setup Guide)
2x 100 Frequency Option Per Channel / Channel 1
–
520 to 544.75Mhz / Channel 2
–
545 to 569.75Mhz
Steps to connect:
1.
Attach both antennas
–
screw into place to secure
2.
Plug in the Power supply to the wall and the connector into the DC Input on the back of the receiver
3.
Plug in your Microphone Jack Cable in MIX OUT and the other end into your amplifier or karaoke machines mic input. (OR if using XLR Jacks to a mixing deck,
connect two XLR cables into Balanced A & Balanced B and the other end into your deck)
4.
Unscrew the bottom of the microphone to reveal the battery chamber and put 2x AA batteries in each microphone. Screw the bottom of the microphone back into
place.
5.
Switch on the power on the receiver and switch on each microphone (power button at bottom, press and hold until LCD screen lights up)
6.
Adjust the volume levels to between the 3
rd
and 5
th
indicator (no higher should be necessary especially when using an amplifier)
7.
Each microphone frequency must be the same as one on the receiver in order to work. (Each microphone must be on a different frequency if they are the same
they will not work together)
7A. To change the frequency, use the up and down arrows on the receiver. Then press the set button, this will set frequency on the receiver and then press it again with the
microphone switched on and nearby the receiver and you will see it sync and the frequency change on the microphone. Once this is done its ready to use.
5
2
7A
6
4
3
1
Rear of Receiver Unit
1
OR XLR-B
OR XLR-A
