Determine the location of the 3” flex bracket and subwoofer.
Ensure there is adequate space to accommodate the
subwoofer and port tube within the 2 x 4 stud bay or joists,
allowing at least 7-9” from the front edge of the BPS6 TL
to the location of the flex bracket opening. (See Figure 1).
Box Contents
(1) Quickstart Guide
(1) Bandpass Subwoofer with port tube
(1) Cardboard mounting template
MOUNTING SCREWS & WASHERS:
(4) 5/16” x 3” lag screws
(4) 5/16” washers
BPS6 TL QUICKSTART GUIDE FOR USE WITH VISUAL
PERFORMANCE SERIES BANDPASS CONNECTORS
BANDPASS SUBWOOFER THINLINE (VP)
Place the subwoofer mounting template on the side of a
2 x 4 stud or joist and drill four 1/4” (6mm) holes through the
locations shown on the mounting template. (See Figure 2).
Hold the side of the BPS6 TL Subwoofer with the rubber
damping pad up against the side of the 2 x 4 stud and
install the four lag screws and washers to secure the
BPS6 TL Subwoofer in place. (See Figure 3).
2
3
1
7-9” (177-228mm)
BPS6 TL
Port Tube
Flex Bracket
NOTE: IF IT IS NOT POSSIBLE TO LOCATE THE BPS6 TL SUBWOOFER
7-9” AWAY FROM THE FLEX BRACKET OPENING, EXTRA HOSE
MATERIAL (UP TO 3”) MAY BE REMOVED. WHILE IT IS OKAY TO
SHORTEN THE HOSE, NEVER EXTEND THE HOSE LENGTH.
NOTE: DRILLING FROM THE INSIDE OF THE STUD BAY IS
RECOMMENDED TO ENSURE THAT THE HOLE LOCATIONS MATCH
THE SUBWOOFER SCREW LOCATIONS.
NOTE: BE SURE THAT THE SUBWOOFER TEMPLATE IS FLUSH WITH
THE EDGE OF THE STUD OR SLIGHTLY RECESSED.
Attach the 3” flex bracket to the 2 x 4 stud or joists in
the predetermined location. Check that the mounted
distance allows for the port tube to pass through the
bracket with at least 4 ribs of the tube exposed.
(See Figure 4).
4
Figure 1
Figure 2
Figure 3
Figure 4
Template
