Pairing with wireless headsets
Please also refer to the manual of the headset for
instructions on how to pair it.
1. Insert the USB BT in the USB port of the phone (Fig.
B-1).
2. Briefly press the pairing button (Fig. B-2).
• The red and blue LEDs of the button flash
alternatingly while the adapter is searching for a
detectable device.
• When the USB BT has detected one, the blue LED
starts to flash rapidly, indicating that pairing is taking
place.
After successful pairing, the blue LED flashes once every 2
or 6 seconds, depending on the type of audio-streaming to
the headset.
When the headset is turned off, the USB BT goes into idle
mode.
Product specifications
Version: Compatible with Bluetooth V2.1+EDR, Class 2
Range: Up to 10 meters, depending on surroundings
USB A
dapt
er for Wire
less Headsets
Quic
k Start Guide
A
B
WLAN
Pairing button
with LED
1
2
© 2010-2011 snom technology AG. All rights reserved.
snom® is a registered trademark of snom technology AG and its affiliates in the European Union, USA, Japan, South Africa, Australia, China and certain
other countries and regions. Unless specified otherwise, all trademarks, in particular product names, are legally protected trademarks of snom techno-
logy AG. Other mentioned trademarks or registered trademarks are the property of their respective manufacturers or owners. Product specifications are
subject to change without notice.
LED status indications:
Status
LED
Idle mode
(headset off)
Blue, pulsing: 2 seconds on, 1
second off
Pairing mode, se-
arching for detectable
device
Red + blue, flashing alternatin-
gly
Pairing with the found
device
Blue, flashing rapidly
Standby, indicating type of audio-streaming to headset:
HFP/HSP
Blue, flashing once every
6 seconds
A2DP/A2DP+HFP
Blue, flashing once every
2 seconds
USB Adapter for Wireless Headsets
V2.1 + EDR, Class 2
