background image

SMSC SCH5027E

PRODUCT PREVIEW

Revision 0.2 (02-11-09) 

Data Brief

PRODUCT FEATURES

SCH5027E

Super I/O with 
Temperature Sensing, 
Quiet Auto Fan and 
Glue Logic with PECI

„

General Features

— 3.3 Volt Operation (SIO Block is 5 Volt Tolerant)
— LPC  Interface
— Programmable Wake-up Event Interface
— PC99, PC2001 Compliant
— ACPI 2.0 Compliant
— Multiplexed Command, Address and Data Bus
— Serial IRQ Interface Compatible with Serialized IRQ 

Support for PCI Systems

— PME Interface
— ISA Plug-and-Play Compatible Register Set
— 25 General Purpose Input/Output Pins 
— System Management Interrupt

„

PECI Interface

— Supports PECI REQUEST# and PECI AVAILABLE 

signalling

„

AC Power Failure Recovery

„

Watchdog Timer

„

2.88MB Super I/O Floppy Disk Controller

— Licensed CMOS 765B Floppy Disk Controller
— Software and Register Compatible with SMSC's 

Proprietary 82077AA Compatible Core

— Supports One Floppy Drive
— Configurable Open Drain/Push-Pull Output Drivers
— Supports Vertical Recording Format
— 16-Byte Data FIFO
— 100% IBM® Compatibility
— Detects All Overrun and Underrun Conditions
— Sophisticated Power Control Circuitry (PCC) Including 

Multiple Powerdown Modes for Reduced Power 
Consumption

— DMA Enable Logic
— Data Rate and Drive Control Registers
— 480 Address, Up to Eight IRQ and Three DMA Options
— Support 3 Mode FDD 

„

Enhanced Digital Data Separator

— 2 Mbps, 1 Mbps, 500 Kbps, 300 Kbps, 250 Kbps Data 

Rates

— Programmable Precompensation Modes

„

Serial Ports

— Two Full Function Serial Ports
— High Speed NS16C550A Compatible UARTs with 

Send/Receive 16-Byte FIFOs

— Supports 230k and 460k Baud
— Programmable Baud Rate Generator
— Modem Control Circuitry
— 480 Address and 15 IRQ Options

„

Infrared Port

— Multiprotocol Infrared Interface
— IrDA 1.0 Compliant
— SHARP ASK IR
— 480 Addresses, Up to 15 IRQ 

„

Multi-Mode™ Parallel Port with ChiProtect™ 

— Standard Mode IBM PC/XT®, PC/AT®, and PS/2™ 

Compatible Bi-directional Parallel Port

— Enhanced Parallel Port (EPP) Compatible - EPP 1.7 

and EPP 1.9 (IEEE 1284 Compliant)

— IEEE 1284 Compliant Enhanced Capabilities Port 

(ECP)

— ChiProtect Circuitry for Protection 
— 960 Address, Up to 15 IRQ and Three DMA Options

„

Keyboard Controller

— 8042 Software Compatible
— 8 Bit Microcomputer
— 2k Bytes of Program ROM
— 256 Bytes of Data RAM
— Four Open Drain Outputs Dedicated for 

Keyboard/Mouse Interface

— Asynchronous Access to Two Data Registers and One 

Status Register

— Supports Interrupt and Polling Access
— 8 Bit Counter Timer 
— Port 92 Support
— Fast Gate A20 and KRESET Outputs

„

Motherboard GLUE Logic

— IDE Reset Output
— (4) Buffered PCI Reset Outputs with software controlled 

reset capability - default transparent 

— Front Panel Reset Debouncing and Power Good Signal 

Generation 

— Power Supply Turn On Circuitry with Support for power 

button on PS/2 Keyboard

— Resume Reset Signal Generation
— SMBus Isolation Circuitry (2 sets external and 1 set 

internal for Hardware Monitoring Block)

— SMBus 2.0 compliant interface for Hardware Monitoring
— LED Control (2)

„

Fan Control

— 5 PWM (Pulse width Modulation) Outputs
— Low frequency and high frequency PWM support
— 6 Fan Tachometer Inputs 
— Programmable automatic fan control based on 

temperature

— Interrupt Pin for out-of-limit Fantach Events
— Fantach events generate PME’s

Summary of Contents for SCH5027E






Reviews: