![background image](http://html1.mh-extra.com/html/smart-technologies/smart-board-400/smart-board-400_assembly-instructions_1296316001.webp)
SMART Board
TM
Floor Stand Assembly
Assembling the Floor Stand
1. Attach the feet to the uprights using four ¼-20
x 2" stainless steel Phillips flathead machine
screws. Tighten securely using the #3 Phillips
screwdriver provided. One side of each
upright has countersunk indentations around
eight of the screw holes. Ensure that the side
of the upright with the countersunk holes is to
the outside and the angled metal attachments
on the feet both face in the same direction.
2. Loosely fasten each end of the two cross
members to the uprights using four ¼-20 x 2"
stainless steel #3 Phillips flathead machine
screws. After all of the screws are in place,
tighten them securely. The screw heads
must be flush with the outside surface of the
upright.
3. Attach the two SMART Board mounting
brackets at the same height to the uprights
using the four ¼-20 x ½" machine screws
which have black plastic knobs. The Board
mounting brackets are shaped like an "L".
The smaller part of the "L" should be facing
the front of the stand (towards the angled
metal attachments on the feet). The wider
side of each of the mounting brackets, the
one with the holes, must be attached to the
outside of the uprights. The smaller part of
the "L" will be pointing away from the center
and facing the front on the stand (towards the
angled metal attachments on the feet).
Depending upon where you position the
mounting brackets against the stand legs, you
will raise or lower the height of the SMART
Board.
These instructions
apply to Floor
Stands for the
SMART Board 400,
585 and 720.
Note
Do not over-tighten
the screws that
attach the Board
mounting brackets
to the upright.
Some give may be
required when you
attach the SMART
Board.
1.
co
un
te
rs
u
nk h
ole
s
to
th
e
ou
tsi
de
co
un
te
rs
u
nk h
ol
e
s
to
th
e
ou
tsi
de
2.
coun
te
rs
unk h
ole
s
to
the
out
si
de
coun
te
rs
unk h
ol
es
to
the
out
si
de
3.