1
SKYSCAN ATOMIC CLOCK
Model 88825
Instruction Manual
Congratulations on purchasing the jumbo LCD wall clock. The utmost care has gone into the design and manufacture of
your clock. Please read these instructions carefully and store them in a safe place for future reference.
FEATURES
Precise Atomic Time display
Four separate time zones: Eastern, Central, Mountain or
Pacific
Calendar shows Month, Day & Date
Temperature shows in
O
F or
O
C
Alarm clock and snooze function
Displays time in 12 or 24 hour format
Daylight Saving Time function (DST)
Indoor temperature
BATTERY INSERTION / REPLACEMENT
Remove the battery compartment cover on the back of the clock.
Insert three “AA” batteries into the battery compartment. Make sure the polarity is correct by following the (+ or -)
symbols engraved inside.
Do not mix old and new batteries or batteries of different brands.
RECEIVING RADIO SIGNALS AUTOMATICALLY
After inserting the batteries, the display will be activated, but the clock will not operate or set for the first four minutes.
During this time, it will automatically search for the WWVB time signal, and the antenna icon
will flash
.
While the clock is searching for the WWVB time signal, the “WAVE/+” button can be pressed to stop the search for the
WWVB time signal.
If the WWVB signal has been received successfully, the antenna icon
will display continuously and the display will
show the default time, date, and weekday.
STARTING THE SIGNAL SEARCH MANUALLY
In normal time display mode, you can also manually start the reception of the WWVB time signal any time: Press and hold
the “WAVE/+” button for 2 seconds. The antenna icon flashes until the clock has successfully received the WWVB time
signal and a solid antenna icon
will displays on the LCD screen.
NOTE
:
During the search for the WWVB time signal, the setting function will not operate! This is normal and not a
defect in your clock.
