background image

LAUNCH

AUTO

MANUAL

FLYING MODE

R

L

L AUNCH

L AND

OFF

ON

01942

Front

B

A

A

B

POWERING UP AND PAIRING REMOTE

• Reset controller to    

  factory settings:
  Hold F Trim, B Trim,    

  and Power for 
  3 seconds.

Forward/

Backward Trim

Power 

Stunt Button

Auto Mode Indicator

Manual Mode Indicator

Rotation Trim

Left/Right Trim

FLIGHT BASICS

Press 

LAUNCH

 to automatically launch a few feet off the ground.

Move 

LEFT (Throttle)

 thumbstick up or down to make drone fly 

higher or lower and left or right to rotate.

Use 

RIGHT (Directional)

 thumbstick to fly forward, 

backward, left or right.

Press 

LAND

 to automatically land.

Rotate 

Left

Rotate 

Right

Up

Down

FLIGHT CONTROLS

ONE TOUCH STUNTS

Fly Right

Fly Left

Fly Forward

Fly Backward

REPLACING DAMAGED BLADES

AUTO AND MANUAL FLIGHT MODES

Using a fork or  tool, 

gently pry the blade 

from the motor shaft.

To make flying easier, place the drone on the ground in front of you 
with the drone facing away from you (green blades forward). You 
should be facing the same way the drone is facing.

Turn on controller. (Before initial use, 
install new batteries into controller. 
See Reverse.)

 FLYING GUIDE

NANO DRONE

DASH

Place the drone on level surface for 
calibration.

R

L

AUTO

MANUAL

FLYING MODE

LAUNCH

LAND

When LEDs turn solid, the drone is ready to fly. 

AUTO

 mode is best for new 

pilots. Begin by pressing the 
LAUNCH button for takeoff. 
The drone will hold its altitude, 
and gradually fly up or down 
when you press up or down on 
the left thumbstick.

MANUAL

 mode is better for 

experienced pilots. When the 
left thumbstick is pushed all 
the way up the drone will spin 
its motors as fast as it can 
while maintaining stability, and 
when the left thumbstick is 
pushed all the way down the 
motors will stop spinning 
completely. 

Turn the drone on. (Be sure that 
drone is completely charged. 
See reverse.)

NOTE

:

 

Once a stunt has been initiated, DO NOT adjust Throttle or press any other controls until the stunt has been completed.

CAUTION!

The drone should be flying at least 6 feet in the air with a minimum clearance of 6 feet in all directions before 
attempting stunt functions.

FLIP IN 4 DIRECTIONS

1  Bring the drone to a mid-air hover without flying in any 

direction. Remove finger from the RIGHT thumbstick. 

2  While hovering, press and hold the STUNT button.
3  Then quickly tap the RIGHT thumbstick in the direction 

you want the drone to flip. 

BARREL ROLL LEFT OR RIGHT

While flying forward (or reverse), tap the STUNT button.

R

R

L

LAUNCH

LAND

R

L

AUTO

MANUAL

FLIGHT MODE

LAUNCH

LAND

R

L

AUTO

MANUAL

FLIGHT MODE

LAUNCH

LAND

Flight Mode

LAUNCH/LAND BUTTON

PRESS TO LAND

PRESS TO LAUNCH

If for any reason you need to immediately stop the drone, hold down the stunt 
button (for drones that don't have a stunt button, use the video button) and 
move both thumbsticks down and away from the center of the controller.

Alternatively you can use the left thumbstick to land 
the drone. Hold the left thumbstick all the way down 
for about 2.5 seconds after the drone has safely 
reached the ground, and the motors will stop spinning.

To change the speed of 
the drone, hold STUNT,                             
 

, and      . The LED on 

the controller will blink 
once for slow, twice for 
medium, and three 
times for fast.

Reviews: