![background image](http://html.mh-extra.com/html/signamax/e-130-series/e-130-series_quick-start-manual_1268351001.webp)
Quick Start Guide
QSG-EC130XX_A-2-22
999 N.W. 159th Drive
M i a m i , F L 3 3 1 6 9
T e l : 8 0 0 . 4 4 6 . 2 3 7 7
COPYRIGHT 2007 SIGNAMAX, INC. ■ ALL RIGHTS RESERVED ■ SPECIFICATIONS SUBJECT TO CHANGE
CONNECT WITH US
E-130 Series PoE and Ethernet Extenders
Part Number
Primary
Ports
Uplink
PoE
Budget
EC13010
4 Gigabit
1 Gigabit
66W
Unpack the Extender and Check Contents
Wall Mounting Kit - two brackets and four screws.
Four adhesive foot pads
Documentation—Quick Start Guide (this document)
and Warranty Card
Note:
The E-130 Series extenders are for indoor use only.
Note:
Additional documentation can be obtained from
www.signamax.com
Warning:
This product does not contain any serviceable user
parts.
Warning:
Installation and removal of the unit must be carried out
by qualified personnel only.
Warning:
When connecting this device to a power outlet, connect
the field ground lead on the tri-pole power plug to a valid earth
ground line to prevent electrical hazards.
Caution:
Wear an anti-static wrist strap or take other suitable
measures to prevent electrostatic discharge when handling this
equipment.
Caution:
Do not plug a phone jack connector in the RJ-45 port.
This may damage this device.
Caution:
Use only twisted-pair cables with RJ-45 connectors that
conform to FCC standards.
!
!
Mount the Switch
1.
Remove the screws from both sides of the switch.
2.
Place the provided Wall Mount brackets
3.
Screw the Wall Mount bracket into the sides of the switch
Warnings and Cautionary Messages
1.
This equipment must be grounded. Never defeat the ground conductor
or operate the equipment in the absence of a suitably installed ground
conductor. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available.
2.
Attach a lug (not provided) to a #12 AWG (PoE switch) or #18 AWG
(non-PoE switch) minimum grounding wire (not provided), and connect
it to the grounding point on the switch rear panel. Then connect the other
end of the wire to ground.
Ground the Switch
Caution:
The earth connection must not be removed unless all
supply connections have been disconnected.
Note:
The device must be installed in a restricted access loca-
tion. It should have a separate protective earthing terminal on
the chassis that must be permanently connected to earth to ad-
equately ground the chassis and protect the operator from elec-
trical hazards.
!
1.
The E-130 Series can be powered by any standard 802.3 PoE type.
2.
The E-130 Series PoE Ports all support 802.3at up to 30W per port.
3.
Total available PoE budget will be dependent on the PSE providing
power to the extender