Gigaset 2400 Handset and Charger Quick Reference Guide
This guide contains product
specific information that will
help you quickly use your
2400 Handset and
Charger. You must have a
Siemens Gigaset 2420,
2402, 2415, or 2410
system to use the 2400
Handset. Detailed
information about product
features, installation and
use is contained in your
System Owners Manual.
Please read the Safety
Instructions and Product
Information before using
the product.
Registering a Handset to Your Base
The handset that comes with the system is pre-registered to the base unit. Additional
handsets may be purchased to operate with your Gigaset. You can register up to a
total of 8 handsets on 2420 and 2402 and up to a total of 4 on the 2415 and 2410.
ONLY Siemens 2400
handsets will operate with your
Siemens Gigaset
system. To
register additional handsets, you must be near the base unit.
1. Turn handset on by pressing the
PWR
key.
2.
Display will show “Please Register.”
3. Press
the
OK
soft key, enter System PIN, and press
OK
again to begin the
registration mode.
Display will show “Searching.”
4. Within 3 minutes of pressing
OK
, continue the registration on your base.
2420 Base
2402 Base
2410 and 2415 Bases
•
Press
MENU
and scroll to
system settings; press
Select
.
•
Enter System PIN and
press
Select
.
•
Scroll to mobile
registration and press
Select
.
•
Hold down the power
ON/OFF
indicator
and
Registration
button until it flickers
(approximately 4
seconds).
•
Hold down the
Page/Registration
button
until the PWR LED
flickers.
