Reading time: 10min
Full Race Unit installation manual part № “C-K11 C-K11A C-K16 C-K16A”
Please read carefully before attempting any use of this product!
To install the SP-Full Race Unit you will have to:
1.
Gain access to the ignition coils (for best results refer to your motorcycle service manual). Plug in
the female connectors to the ignition coils and the male connectors to the bike's harness.
You must
connect each male and female connector pair to the same corresponding cylinder no matter left to
right or right to left!
This picture is taken from ZX-10R(2015) non ABS model.
IMPORTANT NOTE
: Make sure when plugging the connectors that you press them well enough to lock, as
this will provide sealed and reliable electrical connection, vital for the function of the Full Race Unit. Find
appropriate place for the Full Race Unit control box and route the cables, they are high quality,
automotive class, heat resistant cables but there is some care you should take: Avoid moving parts as
they might damage them, the best way is to follow other cables from the bike's harnes, use the cable ties
provided to fasten them. Make sure the place for the Full Race Unit control box is
away from heavy
vibrations,
heat and it is not constantly exposed to rain and water.
Summary of Contents for C-K11
Page 5: ......
