![background image](http://html.mh-extra.com/html/sharp/xg-v10wm-guide/xg-v10wm-guide_quick-reference-manual_371754001.webp)
How to Connect a Sharp Projector to a Network
Quick Reference Guide
Applicable Models:
XG-V10WU
XG-V10XU
B.) Set IP Address
XG-V10WM
XG-V10XM
NOTE: IP Address is Static - verify with
Quick Reference Guide Sections:
IT / MIS Department.
1.) AN-L10T Installation
2.) Projector Configuration
3.) S.A.P.S. Configuration
1.) Install Lan Card into expansion slot
on A/V connector side of the projector
Refer to Operation Manual - page 5
C.) Set Gateway
Refer to O/M page numbers 2 - 3 for details
There are (4) four items to configure
on the projector menu.
A.) Set ID Number
Refer to Operation Manual - page 6
B.) Set IP Address
C.) Set Gateway
D.) Set Subnet Mask
A.) Set ID Number
D.) Set Subnet Mask
Refer to Operation Manual - page 7
Refer to Operation Manual - page 4
2.) Configure Projector Menu
Must be
obtained from
IT / MIS
Department
L:\tekcentr\cactrain\qck_ref.xls
1
3:18 PM
10/12/2001