SLSFE11
Portable Electronic Safe Box
INSTRUCTIONS
1. TO PROGRAM AND CHANGE
THE USER CODE
a.
First, open the door of your safe,
without turning the rotary knob before
you start to program your safe.
Remove the battery compartment cover on the back of the door and
place the batteries (4x1.5 batteries type AA) into the battery holder
correctly. (Batteries included inside the safe).
b.
While the door is open, press the button behind the door. The yellow
light will be on with a short beep. Please input the user code (from 3-8
digits) using any number from “0” to “9” within 30 seconds, then press “E”
to confirm it.
c.
To change the user code, please use the same procedures as above.
2. TO OPEN THE SAFE
Input the user code you programmed, then press ”E”. The green light will
be on. Please turn the knob within 5 seconds and pull out to open the
safe. If a wrong digit is input, you can press “C” to cancel it.
Note:
With each press the yellow light will flash with a short beep,
indicating that the micro processor confirmed it. If the yellow light keeps on
flashing with the beep, it means the code is wrong. Inputting the wrong
code three times will result in the micro processor refusing to accept the
input for 20 seconds. If you press the wrong code three times again, the
micro processor will refuse to accept input for 5 minutes.
3. TO CLOSE THE SAFE
Close the door and turn the knob counter-clockwise to lock the safe.
www.SereneLifeHome.com
