FFP2 FACE MASK WITH VALVE
PACK OF 12
MODEL NO:
2005V/12
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Ensure that all components are in good order and fit for purpose.
DO NOT
use if you are unsure.
9
The mask is for single use only, and should not be removed from its packaging until it is required for use.
9
Wear the mask for the whole period of exposure. It should not be used for more than 8 hours (1 shift) and should be discarded safely
and appropriately after use.
WARNING!
The user should be instructed on how to fit the mask properly and made aware of these instructions before using the
mask.
WARNING!
Use only in adequately ventilated areas which
DO NOT
have a deficiency of oxygen.
WARNING!
Facial hair or beards and certain facial characteristics may reduce the effectiveness of the mask.
WARNING!
If the mask is removed whilst in the contaminated area it should be replaced.
WARNING!
If the mask is damaged in use it must be replaced.
8
DO NOT
use the mask in an explosive environment.
8
DO NOT
store or transport masks in direct sunlight. Store in frost free, dry conditions.
NOTE:
If the User exhibits an allergic reaction to the mask, they must leave the hazard area and seek medical advice.
2. INTRODUCTION
Pack of 12 cup masks class FFP2 NR. Protects against mild toxic or irritant solid and liquid aerosols. Aerosols are defined as a
suspension of fine solid particles or liquid droplets in air or another gas. Fitted with nose liner and aluminium nose clip to fit all face
contours. Also fitted with breathing vent to provide more comfort and better communication as well as reducing heat build-up. Filter
efficiency ≥ 94%. Manufactured to BS EN 149:2001 + A1:2009.
3. SPECIFICATION
Model No:
...............................................................2005V/12
B
rand:
..................................................................... Worksafe
Q
uantity: ............................................................................12
4. FITTING INSTRUCTIONS
4.1.
Cup mask in one hand with nose piece at fingertips, allow the headbands to hang freely below the hand (fig.1.1)
4.2.
Hold mask under chin with nose piece upwards (fig.1.2)
4.3.
Locate the upper strap across the crown of the head and the lower below the ears, straps must not be twisted (fig.1.2/3/4).
4.4.
Using both hands, mould the nose clip to the lower part of the nose to ensure a close fit and good seal. Pinching the nose clip using
only one hand may result in less effective performance (fig.1.5).
4.5. `
The mask seal on the face should be fit checked before entering the workplace (fig.1.6).
4.6.
If the user feels that the straps are too loose and not possible to achieve a satisfactory seal, the straps may be knotted to shorten
them.
2005V/12 Issue 1 21/10/20
Original Language Version
© Jack Sealey Limited
fig.1
2
3
6
1
5
4
C
E 2797
