PANEL BAG SET 2PC
MODEL NO:
VS9112
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.
9
Familiarise yourself with the application and limitations of the panel bag set, as well as the potential hazards.
9
Maintain the
set in good condition.
9
Replace damaged parts.
Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Maintain correct balance and footing. Ensure floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
put hands/fingers in apertures created by bags without first inserting a mechanical chock to prevent accidental injury
8
DO NOT
use the panel bags for purposes other than those for which they were designed.
8
DO NOT
over-inflate.
8
DO NOT
use on doors fitted with air bags.
8
DO NOT
use when you are tired, under the influence of alcohol, drugs or intoxicating medication.
9
Deflate bag prior to storage.
9
Clean, dry and store in supplied bag.
2. INTRODUCTION
M
ulti-purpose durable air cushion devices with rigid edges and fine air control valve. Suitable for positioning panels, bonnets and boots, prior to
fitment. 2mm thickness and semi-rigid construction allow bags to be slid between window frame and weather-stripping for improved access for
emergency vehicle opening tools. Soft air cushion is gentle on paintwork, frame, beadings and glass. Can also be used for positioning kitchen
units, windows and doors.
3. SPECIFICATION
Model No: ..................................................................VS9112
Load Capacity: ............................................................. 135kg
Bag Dimensions (W x H): ..................................150 x 165mm
Minimum/Maximum Thickness ............................
2mm-70mm
V
S9112 Issue 1 07/10/21
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
