instructions for
description. front wheel bearing
puller - ford transit
model no:
Vs2386
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
warning!
ensure Health and safety, local authority and general workshop practice regulations are adhered to when using tools.
1.1.
observe standard workshop safety procedures.
warning!
take extreme caution when using these tools, components are heavy.
1.2.
maintain correct balance and footing. do not over reach, ensure the floor is not slippery, wear non-slip toe protector shoes.
1.3.
remove loose fitting clothing, ties, watches, rings, loose jewellery, and contain or tie back long hair.
1.4.
Wear approved eye protection, gloves and footwear. A range of personal safety equipment is available from your sealey dealer.
8
do not
use these tools for any purpose other than those for which they have been designed.
8
do not
use with air tools or impact socket
8
do not
use tools if damaged.
1.5.
maintain tools in good and clean condition for best and safest performance.
1.6.
ensure that a vehicle which has been jacked up is adequately supported with axle stands.
1.7.
remove appropriate road wheels and brake calipers.
8
do not
attempt to start engine or move vehicle whilst in gear with tools fitted.
1.8.
Account for all tools and parts being used and do not leave them in or near the engine.
1.9.
these instructions are provided as a guide only. Always refer to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and data.
1.10.
When not in use, clean and store the tools in their case in a safe, dry, childproof location.
2. introduction
Engineered for safe removal of drive flange with wheel bearing from the hub assembly in situ and wheel bearing from drive flange. An essential
tool when replacing brake discs, allowing the drive flange to be split from the hub assembly. Features a cleverly designed impact force screw.
3. specification
model no: .................................................................. Vs2386
Applications ............ front Wheel drive ford transit (2006on)
4. contents
item
sealey Part no.
description
Qty
1
Vs2386.01
impact force screw
1
2
Vs2386.02
flange Adaptor
1
3
Vs2386.03
large Adaptor (Ø76.5mm)
1
4
Vs2386.04
small Adaptor (Ø43.5mm)
1
5
Vs2386.05
Hex screws/Hex nuts (m10)
5
6
Vs2386.06
spanner
1
4.1.
AlWAYs KeeP force screW Well luBricAted.
molYBdenum/coPPer BAsed recommended
8
do not
use Air tools or imPAct socKets.
Vs2386 | issue 1(i) 06/04/16
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear eye
Protection
Wear
Protective
Gloves
2
3
4
1
6
5
fig.1
