instructions for
vacuum oil/fluid extractor 5.5 ltr
model no:
tP696
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SafetY
9
Keep the extractor clean and maintain it in good condition (use an authorised service agent).
9
replace or repair damaged parts. use genuine parts only. unauthorised parts may be dangerous
9
and will invalidate the warranty.
9
Keep all non-essential persons away from the work area.
9
check extractor connections and fittings before use.
9
ensure that the tank capacity exceeds the amount of fluid to be collected.
8
do Not
use the extractor for any purpose other than that for which it is designed.
8
do Not
operate the extractor if any parts are damaged or missing as this may cause failure
and/or personal injury.
8
do Not
leave the extractor operating unattended.
WarNiNG!
engine oil will be hot when extracting.
imPortaNt!
ensure that you wear protective clothing, gloves, goggles, face mask as appropriate
for the fluid being extracted.
WarNiNG! do Not
allow uncontrolled discharge of fluids thus polluting the environment.
8
do Not
use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.
8
the container is not designed for long term storage.
8
do Not
store the unit under extreme conditions.
8
do Not
turn the container upside-down when it is holding fluids.
8
do Not
adapt the unit for any other purpose.
1.1.
dispose of waste fluids in accordance with local authority regulations.
WarNiNG! do Not
use with gasoline or other flammable liquids.
1.2.
When not in use, disconnect from the air supply and store in a safe, dry, childproof area.
2.
i
iNtroductioN
5.5ltr capacity device constructed from composite materials and suitable for the extraction of engine oils from cars, motorcycles,
marine engines, stationary engines and industrial machinery. Suitable also for low viscosity fluids such as water. Supplied
with 2100mm suction probe, easy-pour spout and cover cap. use suction probe to remove engine oil through the dipstick tube.
3.
i
SPecificatioN
capacity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5 litre
overall length of suction probe . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2100mm
4. aSSemblY
Note:
the black section of the probe is permanently joined to the clear section and cannot be separated.
4.1.
screw handle (f) onto pump shaft (B).
4.2.
Replace red cap on container (G) with tube cap (D) and fix fir
mly.
4.3.
Before attaching pump (B), make sure the black rubber collar (e) on contain
er(A) is firmly seated.
fig.1
tP696 issue 2 (H, f) 11/01/18
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear Protective
Gloves
Wear eye
Protection
Wear Protective
clothing
