220bar Pressure Washer 600L/hr 6.5hP
PetroL
Model no:
PWM2500.V2
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safety
1.1.
GeNeraL safety
WarNING! rIsK of fLuID INJeCtIoN.
This washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh. If there is an occurrence of fluid injection seek medical help immediately
WarNING!
Stop the engine and disconnect the mains water supply before changing accessories or performing any maintenance.
WarNING! Do Not
operate the washer if damaged. Replace or repair using recommended parts only. Unauthorised parts may be
dangerous and will invalidate your warranty. Use authorised Service agent only.
WarNING! Do Not
direct jet against yourself or others in order to clean clothes or foot-wear.
9
Keep the washer in good condition. Regular maintenance will give the best and safest performance.
9
ensure you comply with the water supply company regulations before connecting to the mains. If you are connecting to the mains
drinking water supply ensure you have a back flow preventer valve installed.
9
The water supply hose must be reinforced and have an internal diameter of 13mm (1/2”). The minimum water supply rate must be at
least equal to the cleaner capacity. The water temperature must not exceed 50°C and the pressure must not exceed 10bar.
WarNING! Do Not
operate the washer without the water supply connected. To do so will damage the machine.
9
Position the washer as near as possible to the mains water supply.
9
only use recommended washing detergents. Failure to do so may cause corrosion to equipment and hoses.
WarNING!
Use the washer on a flat, level surface, in a horizontal position. Failure to do so will invalidate your warranty.
9
Wear safety goggles and adequate protective clothing and anti-slip rubber soled footwear.
WarNING!
The high pressure jet must be used with caution. ensure you aim the lance correctly at the work surface. Failure to do so
may scatter loose particles at the same force as the water pressure, resulting in possible damage or personal injury.
9
Keep all persons and animals at a safe distance from the hose working area. It is difficult to give an exact safe distance as it will depend
upon your circumstances. We recommend at least 15 metres (16 yards). Also ensure other persons are aware before you start to
depress the washer trigger.
9
Hold the gun firmly for it will tend to “kick” backwards when you first pull the trigger.
8
Do Not
allow children or untrained persons to operate the washer.
8
Do Not
connect other appliances to the washer inlet or outlet. Only use the supplied or recommended outlet nozzle.
8
Do Not
use the washer if the water supply hose is damaged. Also check that the hose is laid out straight and safely.
8
Do Not
jam the operating trigger in the operating position, and
Do Not
pull the trigger without holding and aiming the gun correctly.
WarNING! Do Not
attempt to alter the pressure regulating valve as this may cause serious damage.
8
Do Not
move the washer by pulling on the high pressure hose or the mains water supply hose. Use the machine handle.
8
Do Not
direct jet against yourself, other persons or animals, electrical equipment or the machine itself.
WarNING! Do Not
leave the engine running for more than 2 minutes without operating the trigger, as temperature/pressure increase
may damage the sealing system.
8
Do Not
use the washer if you are tired or under the influence of alcohol, drugs or intoxicating medication.
9
ensure that the hose pressure is discharged before disconnecting the mains water hose.
9
When not in use, disconnect from the water supply. Clean and dry the washer and store in a safe, dry, frost protected, childproof area.
8
Do Not
allow the machine to become frozen.
1.2.
eNGINe safety
WarNING!
Check the engine oil level before each start up. Only use an approved oil and never operate the engine with insufficient
oil.
WarNING! Do Not
touch spark plug or plug lead whilst the engine is running; severe, potentially fatal, electric shock may result.
9
For safety instructions relative to the maintenance and use of the petrol engine refer to the engine instruction manual.
9
ensure that only the correct fuel type and grade is used.
8
Do Not
check ignition system by removing the spark plug or spark plug lead. Use specific tester or contact service agent.
8
Do Not
use combustion engine powered machines indoors unless adequate ventilation is assessed by national labour authority.
PWM2500.V2 Issue 1 29/11/19
Original Language Version
© Jack Sealey limited
Refer to
instructions
Hot surfaces
Wear eye
protection
Wear ear
protection
WarNING: the engine is shipped without oil.
the pump is shipped with oil. therefore only
the engine must be filled with the correct type
and quantity of oil.
See section 3 for Oil specifications
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
Do Not
direct jet
against yourself,
other
persons, animals,
electrical
equipment or
the machine itself
