HYDRAULIC PULLER SET
MODEL NO:
PS982.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using tools.
8
DO NOT
use tools if damaged or worn.
9
Maintain the tools in good and clean condition for best and safest performance.
9
Ensure all threads are clean and well lubricated.
9
Always check that puller is correctly assembled and is square with the workpiece.
9
If vehicle is raised, ensure it is adequately supported with axle stands, ramps, etc. as appropriate.
9
Wear suitable clothing to avoid snagging. Do not wear jewellery. Tie back long hair.
9
Wear approved eye protection. A full range of personal safety equipment is available from your Sealey dealer.
9
Where possible shield workpiece with canvas or similar to provide protection against failed parts.
8
DO NOT
heat puller jaws when heating a gear or bearing as this will affect the temper and, therefore, the strength of the material.
8
DO NOT use any tool or lever to turn the ram tommy bar, use hand effort only.
8
DO NOT
hit workpiece, or ram, with a hammer if workpiece has not moved with maximum puller force applied. Use a larger capacity puller.
9
Account for all tools and parts being used and do not leave them in or on the vehicle.
IMPORTANT:
Always refer to the vehicle manufacturer’s service instructions, or proprietary manual, to establish the correct procedure
and data. These instructions for use are provided as a guide only.
2. INTRODUCTION
PS982 consists of a set of gear pullers and a forged steel bearing separator, all operated by a 10 tonne hydraulic ram. The ram is also compatible
with sets PS981 and PS983.
3. CONTENTS
PS982.V2 Issue: 5 (W) 12/11/18
Original Language Version
© Jack Sealey Limited
Refer to
Instructions
Wear Eye
Protection
Item
Part No.
Description
1
PS982/8004
Leg, 100mm x 3
2
PS982/8006
Leg, 150mm x 3
3
PS982/8008
Leg, 200mm x 3
4
PS982/9016
Rod, Main x 2
5
PS982/9017
Rod, Extension x 2
6
PS982/8011
Ring, Ram Adaptor
7
PS982/8014
Rod, Ram Extension, 50mm
8
PS982/8015
Rod, Ram Extension, 100mm
9
PS982/8013
Centre Adaptor, 1¼”
10
PS990
Ram, Hydraulic, 10 tonne
11
PS982/9013
Head, Triple
12
PS982/8012
Head, Twin
13
PS982.V2-B
Bearing Separator, 75-105mm
14 PS982/9014 Beam
PS982/OIL
15gm of oil for a single refill
(not
supplied)
PS982/8002
Repair Kit for PS990 Ram
(not
supplied)
