background image

Lifts and stabilises front or back end of hard and soft tail cruiser style bikes quickly and safely. Features adjustable arm height and soft PVC 
sheath for protection to underside of bike. Design of stand ensures rim and tyre protection and once bike is supported, allows easy removal of 
front or rear wheel.

 

DO NOT

 sit on the motorcycle on the stand. 

 

DO NOT

 start the motorcycle on the stand. 

 

DO NOT

 mount the stand on tarmacadam, as the surface may be unstable.

 

DO NOT

 use the stand for a purpose it is not designed to perform.

 

DO NOT

 use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.

 

DO NOT

 allow untrained persons to operate the stand.

 

DO NOT

 make any modifications to the stand. 

 

DO NOT

 operate the stand if parts are missing or damaged.

 

Maintain the stand in a good clean condition for the best and safest performance.

 

Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there is   

 

adequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the stand   

 

and the motorcycle.

 

Maintain correct balance and footing whilst positioning the motorcycle on the stand, do not over reach.

 

Ensure that the floor is not slippery, wear non-slip footwear.

 

Keep children and unauthorised persons away from the work area.

 

Always support the motorcycle to prevent falling sideways (stabiliser).

 

Before removing a motorcycle from the stand, ensure that there are no obstructions or persons around the motorcycle. 

 

When not in use, store in a safe, dry, childproof location.

 

Model No: .......................................................................MPS2

 

Minimum/Maximum Height: ....................................200/275mm

 

Maximum Lift Capacity: ...................................................180kg

 

Note:

 This stand is only intended to lift part of the total weight of the motorcycle.

Original Language Version

MPS2    Issue: 1 - 03/06/14

© Jack Sealey Limited

INSTRUCTIONS FOR: 

TWO ARM CENTRE STAND

MODEL NO:

 MPS2

 1.  SAFETY

IMPORTANT:

 

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE 

PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these 
instructions, and properly maintained, give you years of trouble free performance.

 2.  INTRODUCTION

 3.  SPECIFICATION

 4.  ASSEMBLY

fig.1

 

Refer to fig.1.

4.1. 

Visually inspect and measure the motorcycle to be lifted. Check that there is nothing underneath that will be damaged when it is lifted up.

4.2. 

Assemble the handle, ensure that it is cranked downwards.

Reviews: