Scinomix Sci-Print VX2 Troubleshooting Manual Download

Page: 1 / 3

TS-1018
8/26/2015

Scinomix, Inc.

How to Square the Z-Axis

Purpose

This troubleshooting guide will show how to square the Z-Axis for the Sci-Print VX2/VXL.
Please follow the steps below to properly square the Z-Axis.

Who Should Use This Troubleshooting Guide?

Technician

Instructions

How to square the Z-axis.

Remove the 4 hood screws using a 3mm allen wrench.

If equipped remove the grounding strap located at the top left corner of the
upper gantry

Remove the hood and set aside.

Press the E-stop or turn unit off, and cut off airflow

Summary of Contents for Sci-Print VX2

Page 1: ...he steps below to properly square the Z Axis Who Should Use This Troubleshooting Guide Technician Instructions 1 How to square the Z axis a Remove the 4 hood screws using a 3mm allen wrench b If equipped remove the grounding strap located at the top left corner of the upper gantry c Remove the hood and set aside d Press the E stop or turn unit off and cut off airflow ...

Page 2: ...table for working I like to have it positioned in the middle as shown below f Look to the back side of the upper gantry where the X axis bearing rail and circuit board is located This is where the Z arm is attached and where the adjustment will be made as shown below ...

Page 3: ... are 4mm allens h This step is easier with the help of someone to hold the arm Straighten the arm perfectly straight so the bracket is flush to the arm i When you have the bracket flush and the arm looks as straight as possible tighten the screws as tight as you can without stripping them Version Number Change Date Effective Approved by A New 8 2015 ...