1
sweep
A Note About Our Target Audience:
This kit is for those that enjoy DIY projects. It
will require a good bit of tinkering to get the
results you want. If you have questions, which
you likely will, make it an opportunity to
become a member of our forum
(
http://community.scanse.io/c/3d-scanner
). We
hope you have fun building it and learning how
3D scanners work.
Software for This Project Can Be Found At:
https://github.com/scanse/sweep-3d-scanner
3D Models for This Project Can Be Found At:
https://www.hackster.io/scanse/sweep-3d-
scanner-035a5f
Documentation Revision Information
Rev
Date
Changes
0.93
5/16/2017
Initial Release
0.94
5/24/2017
Updated Sweep Install Photo
0.95
6/19/2017
Updated Sweep Scanner Bracket &
Scanner Cover design
Table of Contents
Introduction ................................................. 2
Tools Required (not Included) ...................... 2
3D Printing the Enclosure Parts .................... 2
3D Scanner Kit Contents ............................... 2
Test Fit All Parts ........................................... 3
Step 1. Install Bearings in Cover.................... 4
Step 2. Assemble Limit Switch ...................... 5
Step 3. Install Stepper Motor ....................... 6
Step 4. Assemble Motor HAT ........................ 7
Step 5. Assemble Female Micro USB Cable ... 8
Step 6. Install Bubble Spirit Level .................. 9
Step 7. Install Raspberry Pi Assembly ......... 11
Step 8. Install 90 Degree Scanner Bracket ... 12
Step 9. Assemble Battery Holder ................ 17
Step 10. Install 9 Axis IMU .......................... 20
Step 11. Install Battery onto the Scanner.... 22
3D Scanner Exploded View
