![background image](http://html.mh-extra.com/html/samsung/stp131-series/stp131-series_operators-manual_352422001.webp)
STP131 Series
Operator's Manual
Warning - U.S
This equipment has been tested and found to comply with the limits for a Class A
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interface when the equipment is
operated in a commercial environment. This equipment generates uses, and can
radiate radio frequency energy and, if not installed and uses in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Notice - Canada
This Apparatus complies with class "A" limits for radio interference as specified in
the Canadian department of communications radio interference regulations.
Caution
Some semiconductor devices are easily damaged by static electricity. You should
turn the printer "OFF", before you connect or remove the cables on the rear side,
in order to guard the printer against the static electricity. If the printer is damaged
by the static electricity, you should turn the printer "OFF".
Get appareil est conforme aux normes class "A" d'interference radio tel que
specifier par ministre canadien des communications dans les reglements
d'interference radio.
Introduction
The STP131 Series Roll Printer are designed for use with electronic instruments such
as system ECR, POS, banking equipment peripheral equipment, etc.
The main features of the printer are as follows:
1. High speed printing : 17.3(1/6" Feed) lines per second.
2. Low noise thermal printing.
3. RS-232(STP131 Series), Parallel(STP131 Series)
4. The data buffer allows the unit to receive print data even during printing.
5. Peripheral units drive circuit enables control of external devices such as
cash drawer.
6. Characters can be scaled up to 64 times compared to it's original size.
7. Bar code printing is possible by using a bar code command.
8. Different print densities can be selected by DIP switches.
Please be sure to read the instruction in this manual carefully before using your
new STP131 Series.
NOTE : The socket-outlet shall be near the equipment and it shall
be easy accessible.
DATE: July. 2001
MANUAL REVISION 2.0
TEL
:
82-31-210-5620
FAX
:
82-31-210-5589