Plastic Lockers – 90000 Series
Models 90168 & 90368 Ten Tier
Assembly Instructions
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-562-5377 Int’l Phone: 323-846-6700
Fax: 1-800-562-5399 Int’l Fax: 323-846-6800
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 12/8/2010) Page 1 of 3
Thank you for selecting Salsbury 90000 Series Plastic Lockers. We are confident that the quality and construction of the lockers will prove to be a
good investment. These instructions are intended to assist you in the assembly of the lockers. Individual job conditions will dictate whether the
lockers must be anchored to the wall, the floor, or both.
Please read the entire assembly instruction document before beginning assembly.
Step 1.
Insert the back panel tabs into the pockets along the rear
edge of the side panel. Tap with soft mallet to engage two (2) latch
points.
Step 2
. Press another side panel onto the tabs on the other side of
the back panel. Tap to engage as above.
Step 3.
Join and press down the sides-and-back-panel assembly
from step 2 above into the base panel as shown below. The base
panel is the thicker of the six (6) horizontal panels provided. Then
thread four (4) leveling feet provided into the bottom of the base
panel.
Step 4.
Install a thinner top horizontal panel on top of the unit.
Step 5.
Assemble four (4) identical units the same as Steps 1
through 4, except installing the thinner top panel on each instead of
the thicker base panel. These units will not have leveling feet.
Step 6.
If no optional sloping hood is ordered, install the three (3)
filler strips into the recesses in the top panel of one (1) of the upper
units. This will be the uppermost unit after the units are stacked.
SIDE
PANEL
BACK
PANEL
OTHER
SIDE PANEL
BASE PANEL
(THICKER)
SIDE
PANELS
TOP
PANEL
BACK
PANEL
LOWER
(FIRST)
UNIT
UPPER
(2
nd
, 3
rd
, 4
th
, 5
th
)
UNITS
LEVELING FEET
(NOT SHOWN)
TOP PANEL
(THINNER)
LOWER
(FIRST)
UNIT
FILLER
STRIPS
FILLER STRIPS
INSTALLED
