INSTALLATION INSTRUCTIONS
RSMKOOS ON/OFF AC LINE SWITCH KIT (STOCK NO. 136-3127)
– For Use with Drive Model RSMK24DF (Stock No. 136-3112) –
RS Components Ltd.
© 2017 RS Components Ltd.
PO Box 99, Corby, Northants. NN17 9RS
United
Kingdom
(A40340) – Rev. A00 – 6/19/2017
www.RSPro.com
Page 1 of 2
SAFETY WARNING!
Read the Safety Warning, on page 5, in the
RSMK24DF Installation and Operation Manual
, before proceeding.
Items Included in this Package
On/Off AC Line Switch (prewired and containing a Hex Nut), Hardware Bag (containing an Open Ended Wrench and a Knurled Ring Nut), and
Installation Instructions.
DESCRIPTION
The On/Off AC Line Switch is used to turn the power on and off to the drive. The switch assembly is designed to be mounted inside the drive,
on the mounting bracket provided. The switch has a hex nut, installed at the base of the bushing, which is not to be removed, but may be
adjusted, if desired, to set the amount of bushing that protrudes through the cover when the switch is installed. The round switch nut, provided,
is used to secure the switch onto the mounting bracket before connecting it to the terminals on the drive's PC board. The instructions below
outline the installation of the On/Off AC Line Switch.
Tools Required:
#2 Phillips Screwdriver and 9/16" Open Ended Wrench (supplied).
DISCONNECT MAIN POWER TO THE DRIVE BEFORE PROCEEDING WITH INSTALLATION
1 REMOVING THE COVER
Use the Phillips screwdriver to remove the four (4) 6-32 X 3/8" cover screws,
shown in Figure 1.
Carefully slide the cover off until it is disengaged from the base. Lay the cover
upside down on the left side of the base.
Note:
The drive contains a ribbon cable which connects the drive's PC board
to the keypad. When removing the cover, use care so the ribbon cable does
not get pulled off its connector.
2 PREPARING THE DRIVE
Remove the hole plug that is installed in the mounting bracket. Remove both
line jumpers that are installed on the drive's PC board Terminals L1A / L1B and
L2A / L2B.
Figure 2 shows the location of the hole plug and the line jumpers.
Figure 3 shows the hole in the mounting bracket with the orientation key and
location of the terminals to connect the switch.
FIGURE 1
FRONT COVER
I
FIGURE 2
LOCATION OF HOLE PLUG AND LINE JUMPERS
FIGURE 3
HOLE PLUG AND LINE JUMPERS REMOVED
