K
FF13 PORTABLE 3PH ELECTRIC HEATER
OPERATING INSTRUCTIONS
PLEASE ENSURE YOU HAVE READ AND UNDERSTOOD THESE INSTRUCTIONS FULLY,
BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT.
IMPORTANT NOTE
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD DAMAGE THIS EQUIPMENT & WILL
INVALIDATE THE WARRANTY!
GENERAL SAFETY
Never place anything on top of the unit and never obstruct its air intake / exhaust grilles.
Leave a 600 mm gap all round the unit to let the air circulate.
Always switch OFF and unplug the equipment when not in use.
ELECTRICAL SAFETY
These models connect to a standard 4 Pin (or 5 pin) 16 amp 415v 3 phase 50 Hz power
supply socket via its mains lead (an inline plug will need to be fitted), they do not require a
neutral & are not Phase Rotationally Sensitive.
THESE MODELS ARE DESIGNED FOR INTERNAL USE ONLY. Do not use externally.
Extension leads should be; correctly rated for the inductive load, fully unwound, loosely
coiled and never run through water or over sharp edges.
Ensure the machine is set to 0 (Off) and the electrical supply is switched OFF before
plugging into the power supply.
Never remove any panels/covers whilst the unit is connected to electrical supply.
If problems are experienced, contact the supplier if the problem cannot be easily & safely
rectified.
Competent personnel in accordance with the instructions or supplier guidelines should only
attempt maintenance.
SET UP & OPERATION
