R6
POWER DISTRIBUTION MODULE
Instruction Manual
Thank you for your purchase. The PDM60 unit was designed with one goal in mind: to provide you, the owner, with
years and years of superior, hassle free electrical performance.
Package Contents:
1pcs PDM60 Power Distribution Module
1pcs
Black 9” ground cable with protection boot
(connect the ground cable to your battery ground, and it serves as a common ground point for all of your accessories)
6pcs ¼” ring terminal – used on your accessories’ ground wires for connections to ground points/ground bus cable
1pcs 6MM bolt/nut
(used for connecting all accessory ground wires/ring terminals to the main ground cable)
6pcs Posi-Lock Connectors
– one per circuit output wire – to allow for secure connections, and quick & easy installation
1Pcs Posi-Tap Connector
– the tap connector is to be used on the “Ignition Trigger” wire – tap into any switched circuit
Overview:
The PDM60 provides 6 individual circuits, with a total load handling capability of 60 Amps. The unit is designed to connect directly to a
primary (12V) power source (vehicle battery), and efficiently power, protect and monitor the supply of power to your electrical/electronic
devices.
A stock configuration is installed on all PDM60 units when they ship from the factory. If desired, the unit is ready to use, fresh out of the
package, without any additional programming. The stock configuration is shown in the screenshot below.
Programming Dashboard
You are also able to create your own custom configuration, and load it into the PDM60 using a PC/laptop via the programming
dashboard, and custom programming cable.
You’re able to configure individual circuit amperage limits, individual circuit triggering
methods, circuit delay activation and delay off settings. Below is a screenshot of the dashboard program.
You’ll need to have a
Windows compatible PC with .NET Framework 4 installed. The link below will allow you to download the appropriate .NET files as
needed.
http://www.microsoft.com/en-us/download/details.aspx?id=17851
The dashboard programming software is available for download
at our website:
www.rowe-electronics.com
Simply click on the Products tab, and select the PDM60 link on the left. If you have any
difficulty, feel free to contact our office for additional support.
** Note
- When
Programming the
PDM60, make
sure to have the
programming
cable oriented
as shown in the
photo above;
yellow wires
closest to the
circuit wires.
