114310 Issue D
ECN 07 007
INSTALLATION INSTRUCTIONS CANOPY HOOD
Model No:
RHCV9G – VETRO WALL
(PLEASE NOTE PRODUCT MAY VARY SLIGHTLY FROM THE PICTURE)
PRE-INSTALLATION
Thank you for purchasing a quality, stainless steel canopy hood.
We have a high standard of quality control and each canopy hood is tested and approved before it
leaves the factory.
IMPORTANT
•
Please read the entire instructions before installing the canopy hood
•
Always switch the power off prior to installation, servicing or cleaning the canopy hood.
•
Never use the canopy hood without the filters.
•
Stainless steel is very easily damaged during installation if abraded or knocked by tools.
•
Note all ducting must comply with local requirements and building codes.
•
A power outlet should be within 1200mm from the motor assembly and can be either on the
wall, behind the chimney or in the ceiling.
All electrical work must be done in accordance with local and/or national electrical
codes as applicable. For safety, this product must be earthed. If you are unfamiliar with
methods of installing electrical wiring, employ the services of a qualified electrician.
Turn off power at service entrance before installing wiring or servicing this product.
lbs
The canopy hood is heavy please ensure adequate care when installing the canopy
hood to prevent personal injury.
The canopy hood must be installed onto a solid wall or solid stud. (Weight = 18 Kg)
CONTENTS
Contents of packaging
Equipment Required
Optional Accessories
1 x Canopy hood
Electric Drill
Drill bits
Charcoal Filter
2517
2 x Chimney pieces with bracket
Screwdriver
Spirit Level
Light Bulb
114313
1 x Installation instructions
Duct tape
Tape measure
Chimney Ext (10’)
2194
2 x Filter (Part Number 114311)
Jig saw
Knife
Chimney Ext (12’)
2195
Installation kit (Part Number 114326)
Ladder
Saw
2 x 12 x 2’ Screw
4 x 15 Dia Washer
2 x Wall Anchor Plastic
2 x 8 x 1.25’ Screw
4 x M4 x 8 Pan Head Screw
HEIGHT OF CANOPYHOOD
C
FILTER SURFACE
HOB TOP
B
A
A=650mm(electric cook top)
min
A=650mm(gas cook top) min
B=305mm
C=220mm
•
The canopy hood is designed for 2400mm
ceilings.
•
The chimney is telescopic and is designed for
hood installations between 650 to 750mm above
the cooking surface.
•
Ascertain the desired installation height of the
canopy hood.
•
Any installation above 750mm will compromise
the extraction performance.
•
The air outlet from the motor requires 150mm
round ducting which requires 170mm diameter
hole in the ceiling.
CONTROL PANEL
Timer switch: Canopy hood will remain on a low,
mid or high speed for 15 minutes to clear away all
residual cooking odours before switching off
automatically
.
Timer Speed settings
Lights
