Earmold shown above are not included as standard ac-
cessories.
* The communication connector serves for adjustment of
the hearing aid by the hearing aid professional.
Battery Placement
1. Set the O-M2-M switch of the hearing aid to
"O" (power off).
2. Peel off the sticker on the positive side of
battery (PR48 or 13 zinc-air battery).
3. Open the battery holder with the tip of your
finger.
4. Insert the battery into the battery
holder.
You do not have to worry
about the polarity
.
5. Close the battery holder.
Battery life
(PR48 or 13, for continuous use)
ANSI:
Approx. 270 hours
IEC:
Approx. 290 hours
- Battery life will change depending on the operat-
ing condition.
Putting on Hearing Aid
1. Place the hearing aid on the ear.
Earmold
HOW TO USE YOUR FIRST HEARING AID
Any hearing aid cannot return level of your hearing to normal or
halt further hearing deterioration, but proper use of your hearing
aid can help you hear what is going on around you and let you
get more enjoyment of life.
If this is your first hearing aid, you - like most new users - will
probably be surprised at the loudness of the sounds, and after
using it for a short while, you may even feel that it is too noisy. The
following three tips are important in overcoming your concerns.
1) Read this manual and become familiar with the hearing aid's
various mechanisms and how to use them correctly.
2) First, use your hearing aid in a quiet place and listen to quiet
sounds and give yourself sufficient time to get accustomed to
the sound of your hearing aid.
3) If any physical problems develop, consult your doctor.
FOR KEEPING YOUR HEARING AID LONGER
Always keep the hearing aid clean. Clean the hearing aid with dry
cloth periodically and also remove earwax plugged in the earpiece
or earmold using eyebrush or toothbrush.
Do not expose the hearing aid to the heat from stoves, etc. Also,
avoid leaving it in places with high humidity.
Operate the controls with care. Do not press hard.
If the hearing aid is dropped in water, wipe with dry cloth and ask
the dispenser for check.
Do not pick the microphone with nail, pin, etc., because this may
damage the microphone.
Do not disassemble or attempt any repairs by yourself. Ask the
dispenser for repair.
3-20-41 Higashimotomachi, Kokubunji, Tokyo 185-8533, Japan
HB-G2U
DIGITAL
HEARING AID
(off) (on) (on)
O M 2 M
or
(off)
(on)
Select "M".
O M 2 M
Turn up to
increase volume.
Turn down to
decrease volume.
Wind cover
Volume control
*Communication
connector
O-M2-M switch
Battery holder
Earmold
"Either way"
circuit
Hook
Microphone
OPERATING INSTRUCTIONS
Parts and Controls
Earpiece
2. Turn the power on.
3. Adjust the volume control to a suitable level.
Volume control
Higher numbers mean louder sound.
* Adjust the volume according to the situation (volume of
other voices, ambient noise, etc.).
