DECLARATION OF CONFORMITY
Manufacturers Name:
CableJoG Ltd.
.
Address:
18 Browmere Drive, Croft,
WARRINGTON. CHESHIRE WA3 7HT.
U.K.
Type of equipment:
Cable tester
Model:
RibbonJoG mkII
I hereby declare that the equipment specified above conforms to the provisions of the EC
DIRECTIVE 2004/108/EC on Electromagnetic Compatibility (EMC)
Having applied the following standards;
BS EN 61000-6-1 :2007
“Generic EMC Immunity Standard for the residential, commercial
& light industry environment”.
BS EN 61000-6-3 :2007
“Generic EMC Emissions Standard for the residential, commercial
& light industry environment”.
RibbonJoG
®
mkII
operations manual
Please read the following instructions carefully before using the RibbonJoG
®
mkII Cable Tester.
Warning:
The Cables to be tested must be fully disconnected from any other
equipment or electrical source. Failure to do so could result in electrical
shock and permanent damage to the RibbonJoG
®
mkII Cable Tester, for
which the manufacturer and suppliers can accept no liability.
Introduction
The RibbonJoG
®
mkII Cable Tester is a versatile ribbon cable tester. It allows
the user to either identify a correctly made standard ribbon cable, or carry out
rapid comparison tests having stored known good cable details.
Cables fitted with any of the following standard 0.1" (2.54mm) pitch
connectors may be checked:
The RibbonJoG
®
mkII Specifications:
10 way
14 way
16 way
20 way
26 way
Continuity ( end to end ), less than 4.7K ohms
Short Circuits (end to end and between connected pins), less
than 4.7K ohms
Open Circuits (end to end and between connected pins),
greater than 10K ohms
Less than 1 second test time
Minimum distance between connectors of same size only
130mm
Non-volatile memory feature
34 way
40 way
50 way
60 way
64 way
11. Adaptor boards
Board #1
New 0.1" or 2.54mm x 2.54mm connector sizes 6, 8, 12, 24, 30 &
44 way
Fitting Instructions:
1. Plug into the 64 way connector slots ensuring alignment of fixing holes
with mounting posts.
2. Secure the board with the four m3 screws.
