STEP 2
Insert Spacers into appropriate holes on the part
“Base”. Amount of Spacers and its location depend onthe
type of board you want to install.
STEP 4
Screw the board of your device by using applied
screws. Amount of the screws depends on amount of the
Spacers that are used for your board.
STEP 6
Fix the Lower part by using 3 applied screws.
STEP 1
Insert panel into the gap in the part “Base”.
Choice of the panel depends on board you want to use for
installation in StationBox™. The package of the StationBox™
includes 4 different types of panels dedicated for 4 different
boards. Other panels can be ordered at your supplier.
STEP 3
Place the board of your device into holes on
the front side of part “Base” and on appropriate positions
considering the Spacers.
STEP 5
Insert Lower part into “Base” according to the
picture.
STEP 7
Attach antenna using 2 screws at the upper part
of antenna (using free holes), according to the picture.
Then, connect the pigtail to the radio.
STEP 8
Whole entity fix by using 2 screws according to
the picture.
