Truss Fork Pack Installation Guide
Thanks for purchasing a set of the Jones Truss Fork Packs! When installed properly, these packs will provide a stable, and roomy storage compartment, so take a
moment to read and understand this guide! Note that the strap paths are a little complicated, and the
packs are left and right specific!
Step 1: Determine which side of the fork each pack should fit. The top-attachment strap is at the leading edge of the pack. The other way to tell is that when the
pack is in position, the bottom of the Jones logo will be toward the rear of the bike.
Step 2: Loop the top-attachment strap around the medial brace of the truss fork and thread the webbing through the ladder lock until almost all of the webbing is
fed through. See photo below, which is of the non-drive side pack being mounted. Note that the top-attachment strap is at the leading edge of the pack. At this
point, the pack will hang from this strap as you attach the rest of the straps. You will adjust this more in the next step
.
Step 3: Position lower straps. On non-drive side, straps go under the brake hose (left photo below). You may need to adjust the top attachment strap now. Then
feed upper strap around front fork leg from front to rear, and through the D-Ring at the rear leg of the truss fork (see inset photo below).
