![background image](http://html.mh-extra.com/html/retrospec/cub/cub_assembly-instructions_1446089001.webp)
ASSEMBLY INSTRUCTIONS
CUB BALANCE BIKE
TOOLS
1
STEP 1: UNPACKING YOUR BIKE
STEP 2: FRONT WHEEL
WA R N I N G
• Children using this product should always be
supervised by an adult.
• Never allow this product to be ridden at night.
• For sidewalk use only! Do not ride on streets!
We supply: 1 - 10-function multi-tool.
You supply: Scissors.
Cut the shipping straps on the outside of the box.
Remove the box staples. These are sharp and can cut you as you access the bike. Lift bike out by frame and rear wheel.
Rotate the fork so that it is facing forward of the bike. Place the bike on the ground, so it’s standing upright on the fork dropouts and rear tire
(Fig.1)
.
Cut all of the packing zip ties.
Separate the front wheel from the bike.
Examine your new bike for any visible damage that may have occurred during shipping.
1
-
2
-
3
-
4
-
5
-
6
-
1
-
2
-
3
-
Remove the plastic shipping protector(s) from the fork dropouts and plastic axle protector(s)
(Fig.1)
.
Loosen the axle nuts on the front wheel and insert the front wheel into the fork dropouts. Insert the tab of the safety washers into the small
holes on the outside of the fork dropouts.
(Fig.2)
.
Inspect the wheel to make sure it is centered in the fork
(Fig.3)
. Tighten each axle nut a little at a time with a 15mm wrench, alternating
between sides, until each axle nut is properly tightened.
STEP 3: SADDLE/SEAT POST
1
-
2
-
The seat & seat post assembly will come installed from the factory. To adjust saddle height/position, use the following steps:
Pull the quick release lever attached to the top of the frame seat tube outwards. Insert the seat post/saddle assembly into the seat tube of the frame
to at least the minimum insertion line of the seat post
(Fig.4)
. Adjust the seat to your desired height.
Once you have adjusted the seat post to your desired height, lock it in place by closing the quick release lever against the clamp
(Fig.5)
.
The lever should begin to offer resistance at about the half way point in its travel. The lever should require some force to close. If it closes too easily
and does not hold the seat post in place, or if the effort to close the clamp is too great, adjust the clamping force by loosening or tightening the
adjusting nut on the side opposite the lever.
WARNING!
Never adjust the seat height so that the minimum insertion line at the lower end of the seat post is showing outside of the frame
(Fig.4)
.
2
4
5
3
Front