THIS APPLIANCE MUST BE INSTALLED IN
ACCORDANCE WITH THE RULES IN FORCE AND
USED ONLY IN A SUFFICIENTLY VENTILATED
SPACE.
The Rayburn 200G/L Gas-Fired Cooker provides cooking
facilities only. A single atmospheric gas burner is
thermostatically controlled at cooking rates, and operates
at a low bypass rate when idling.
The exhaust flue connection of the appliance is in Open
Flue form, operating on natural draught.
Facilities included on the cooker are, a heat graduated
hotplate, main oven and lower oven. A timing programmer
is also available, as an optional extra.
Gas connection 15mm O.D. copper.
Open flue outlet 100mm min.
Electric Supply 50Hz 3 amp fused 230V.
Weight of Appliance 275Kg.
In your own interests, and that of safety, all gas
appliances should be installed by competent persons, in
accordance with the regulations in force.
Appliance
The appliance must be installed on a solid level floor or
base of incombustible material which is capable of
supporting the total weight.
Location
The location chosen for the appliance must permit
installation and the provision of a satisfactory flue and an
adequate space for servicing and air circulation around
the appliance. See Section - Installation of Appliance -
General.
REMEMBER, when replacing a part on this appliance,
use only spare parts that you can be assured conform to
the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not
clearly authorised by AGA.
Installation and Servicing Instructions
for Rayburn 200G/L
Gas Fired Cooker
FOR USE IN GB & IE
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THE APPLIANCE
1
01/10 EINS 510974
INTRODUCTION
INSTALLATION INSTRUCTIONS
Technical Specification
Natural Gas
Heat Input
5.6kW
Pressure
G20
20mbar
G25
25mbar
Injector Size
1.82 Bray 460
Pilot Size
38/36A
LP
Heat Input
6.3kW
Nominal Rate
G31 Propane
489 g/h
G30 Butane
497 g/h
Inlet Pressure
G31 Propane
37mbar
G30 Butane
28mbar
Injector Size
1.27 Bray 220
Pilot Size
4209
Consumer Protection
As responsible manufacturers we take care to make sure that our
products are designed and constructed to meet the required safety
standards when properly installed and used.
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING
WARRANTY.
Any alteration that is not approved by AGA, could
invalidate the approval of the appliance, the warranty and could also
infringe the current issue of the statutory requirements.
IMPORTANT:
This appliance could contain any of the materials that are indicated
below. It is the Users/Installers responsibility to ensure that the
necessary personal protective clothing is worn when handling, where
applicable, the pertinent parts that contain any of the listed materials
that could be interpreted as being injurious to health and safety, see
below for information.
Firebricks
– when handling use disposable gloves.
Fire cement
– when handling use disposable gloves.
Glues and sealants
– exercise caution – if these are still in liquid
form use face mask and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre,
Kerosene Oil
– may be harmful if inhaled, may be irritating to skin,
eyes, nose and throat. When handling avoid inhaling and contact
with skin or eyes. Use disposable gloves, face masks and eye
protection. After handling wash hands and other exposed parts.
When disposing of the product reduce dust with water spray, ensure
that parts are securely wrapped.
