Installation
Telecenter® IV
Installation
KI-1583A
RAULAND-BORG CORPORATION
l
3450
West Oakton Street, Skokie, Illinois 60076-2951
l
(708) 679-0900
Table of Contents
Page
Introduction ................................................................................................ 1
FCC Requirements ...................................................................................... 2
Initial System Installation and Checkout ..................................................
3
Configure Line-Link Modules .................................................................... 6
Configure Speaker (and Single Link Staff Phone) Control Boards.. ...... 7
Install Field Wiring (Set External EEPROM Switch) ................................ 8
Checkout Internal Communication System ............................................ 12
Install Interconnect Wiring ........................................................................
13
Checkout Interconnect System .................................................................. 16
Physical Number Layout Planning Worksheet (blank form) ..................
17
Introduction
This manual provides instructions for installing and testing a Telecenter IV. Except for the
procedure covering initial system installation and checkout, procedures for installing and
checking-out the internal and interconnected communications systems are kept separate.
Use only the procedures applicable to the site requirements.
Unless otherwise stated, the procedures assume the central chassis has been wired at the
factory, DIP switches have been preset, and the installer has a completed copy of the
System Planning Worksheet.
Special Note:
If interconnecting a Telecenter IV to the public utility, read the
FCC
Requirements
before beginning installation.
©
1989 Rauland-Borg Corporation (Orig. 10/88; Rev. l/89)
Page 1 of 20
