INSTRUCTIONS
EZPAN® HE INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
CAUTION: For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened
fi rmly. Apply weatherproof silicone sealant around the edge of the ceiling mounting box and/or junction box. This is
especially important with an uneven ceiling surface. Silicone all plugs and unused conduit entries.
Fig: 1
Fig: 3
Fig: 4
Fig: 2
RECESSED CEILING MOUNTING
The fi xture is suitable only for
INDOOR RECESSED CEILING
application. Above ceiling access required.
To mount in an insulated or non-insulated ceiling - 9/16” or 15/16”
exposed Flat Tee Grid Ceiling follow the steps below.
1. Firmly bend the pre-installed
Grid Clips
(up and out as shown)
Fig. 1
.
2.
Rotate and slide the
Fixture
as required to fi t through the
Tee-Grid Bar
and place it as indicated by the directional arrow
as shown in
Fig. 2
. Secure the
Fixture
to the
Tee-Grid Bar
.
3. Support wires are required by Installation Codes. Support the
Fixture
to the building structure by
Support Wires
(supplied by
others)
through the
Grid Clip Hole
as shown in
Fig. 3
.
4. Make sure that the orientation of the
Splice Box
and
Access
Plate
faces an accessible tile to make electrical splices.
5.
Loosen
Access Plate Screw
and remove the
Access Plate
.
Knock out appropriate
Conduit Knockouts
on the
Access Plate
to route input conduit. Use appropriate conduit connectors as
required by code as shown in
Fig. 4
.
6. Connect wires as shown in wiring diagram. Push all wires
back into the
Splice Box
. Use appropriate UL approved wire
connectors as required by code to complete wiring. Be careful
not to pinch wires.
WARNING:
To prevent wiring damage or
abrasion, do not expose wiring to edges of sheet metal or other
sharp objects.
7.
Replace
Access Plate
and tighten
Access Plate Screw
.
EZPAN HE 1X4
EZPAN HE 2X2
EZPAN HE 2X4
Access Plate
Conduit
Knockouts
Fixture
Grid Clip
Tee-Grid
Bar
Access
Plate Screw
Splice Box
Grid Clip
Hole
Grid
Clip
Power
Feed
Fixture
Firmly bend
Grid
Clips
up and out
Support Wire
(supplied by others)
1.6”
