background image

REF: LANGAG0419  |  V2.00

FITTING INSTRUCTIONS

CLOSE COUPLED PAN & CISTERN

LANDFORD: DC14014 / DC14013 / DC14012

Fixing nut

Cistern tank

Seal

Flush valve body

Flush valve seat

Plastic nut

Washer

Rubber seal

Reduced flush 

adjustment

Full flush adjustment

Flush valve body

Flush valve seat

INSTALLATION OF FLUSH VALVE

INSTALLATION OF FILL VALVE

Install the fill valve to the tank 
body using the rubber seal and 
plastic nut. Ensure the float cup 
has room to move up and down 
freely. The fill valve is pre-set to a 
height suitable for the cistern tank

FLUSH VALVE ADJUSTMENT

The flush valve is factory set but if adjustment is required see diagram 
below.

IMPORTANT

Flush out all impurities in the cistern prior to installation.

Cistern fittings are suitable for Water pressure: 0.2 - 8 bar

FILL VALVE ADJUSTMENT

The fill valve is factory set but if adjustment is required follow the 
instructions below.

Turn the flush valve 
body anti-clockwise 
to part it from the 
flush valve seat

Install flush valve seat 
and seal as shown

Insert flush valve 
body into flush valve 
seat, turn it 
clockwise until you 
hear a “click”

Open the stopper to allow the float to 
slide up and down. Close stopper once 
float is in position.

FINE ADJUSTMENT

Turn screw for fine adjustment of float 
height. Anticlockwise to lower float. 
Clockwise to heighten float.

Stopper

Brought to you by the Roper Rhodes Group, Brassmill Lane Trading Estate, Bath, BA1 3JF
TEL: 01225 303 900 (R2) | 01225 787 870 (Tavistock)

This product must be installed by a qualified fitter or plumber in accordance with and meet the requirements of the Water Supply (Water Fittings) Regulations 1999 and Scottish Byelaws 2004

Reviews: