Model: 7-501-0
Fig. 1
Fig. 2
Fig. 3
RECEIVER
AC SUPPLY
BLACK
WHITE
BARE
GREEN
WHITE
WHITE
BLUE
BLUE
BLACK
BLACK
RECEIVER
INSTALLING RECEIVER IN CEILING FAN
A: Safety precautions:
●
WARNING:
HIGH VOLTAGE! Disconnect source of
electrical power by removing fuse or switching off circuit
breaker.
●
Do not use with solid state fans.
●
Electrical wiring must meet all local and national electrical code
requirements.
●
Electrical source and fan must be 115/120 volt, 60Hz. Maximum
fan motor amps: 1.0. Maximum light watts: 300W Incandescent
and Halogen.
●
Household electrical power can cause serious injury or death!
B: Installing receiver in fan:
a. Remove electrical power from the circuit.
b. Disconnect existing wiring between ceiling fan and supply at
electrical junction box.
c. Lay the black antenna wire on top of the receiver, and put the
receiver in the mounting bracket. (Fig. 1)
d. Make connections as follows, using the wire nuts supplied
(Fig. 2):
CONNECT
Green fan wire
Black receiver wire (AC IN L)
White receiver wire (AC IN N)
White receiver wire (TO MOTOR N)
Black receiver wire (TO MOTOR L)
Blue receiver wire (FOR LIGHT)
TO
………......…………………….Bare supply wire
...……....……Black supply wire
..……....…...White supply wire
..…….......White fan wire
..……....…Black fan wire
..……...……..Blue light wire
HANDHELD REMOTE CONTROL
If there are wires with different colors, have this unit installed
by qualified licensed electrician.
e. Push all connected wires up into junction box.
f. Lay the black antenna wire on top of the receiver, and put the
receiver in the mounting bracket. (Fig. 2)
g. Reinstall all canopy on the mounting bracket
C. Installing reverse module in ceiling fan
a. Disconnect the switch cup assembly from the bottom of the
fan. (If the fan is a new installation, this cup will not be
attached to the fan yet)
b. Connect the ‘female’ cannon plug on the reverse module to the
cannon plug from the fan flange (Fig. 3)
c. Connect the ‘male’ cannon plug on the reverse module to the
cannon plug in the switch cup assembly.
d. Secure the switch cup assembly to the fan as described in the
fan installation instructions.
SCREWS
SWITCH CUP PLATE
CANNON PLUGS
CANNON PLUGS
REVERSE MODULE
SWITCH CUP
ASSEMBLY
