Motion V CL 14W LED PIR
MODEL: 90498
We are delighted that you have purchased this MICROWAVE lamp.
This lamp is suitable for indoor use only. Please read this instruction
manual before installation and retain for future reference.
IMPORTANT: Never modify the unit, there are no user serviceable
parts inside. Not suitable for use with dimmer switches. Install in
accordance with IEC Wiring Regulations.
THE LIGHT SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN.
HAVE YOUR LIGHT WORK WELL
To achieve the best results, take the following points into account:
1. The sensor will reach the optimum performance when mounted
at a height of more than 2.5 meters
2. Avoid pointing at or positioning close to heat sources such as
heaters or heat extraction units otherwise it may falsely trigger off
the light.
3. Avoid pointing at bright lights as the PIR sensor will not function
when you set Lux control level to dark (
position).
4. Avoid mounting at a strong electromagnetic disturbance, i.e. near
electrical motor or fluorescent lamp ballast.
INSTALLATION(See Figure )
Before commencing any electrical work, ensure the mains supply
cables have been isolated by switching off and removing the relevant
fuse.
1. Open the lamp cover
2. Unscrew the Terminal Block Cover Screw then remove the Termi-
nal Block Cover
3. Connecting the Power Cable (H05RN-F 3G 1mm², not included) to
the Terminal Block, see the relative symbol. Ensure the cable must
pass through the Cable Gasket.
4. Refit the Terminal Block Cover
5. Use the Main body to mark the position of screw holes onto
mounting surface. Drill the wall to depth of about 30 mm and fit
the plastic plugs, and then fix the Cover to the mounting surface
with rightly screws. Be careful to avoid drilling or screwing into
concealed electrical wiring.
6. Refit the lamp cover
