PWD303 - ADD ON STARTER
INSTALLAER’S GUIDE
1. GREEN/WHITE wire has a 0.8 sec negative (-) pulse upon remote starting. BLUE wire is a
constant ground (-) upon remote starting and while engine is running. These wires can be used
to bypass (turn off) some O.E. alarm systems as well as control any external relays that may
be needed.
2. ENSURE the BROWN door/hood wire is ground (-) in conjunction with a pin switch
(supplied) when the hood is open. This is a safety feature to stop accidental remote starting of
the engine whilst the hood is open.
3. PURPLE wire detects engine is running… system is factory set for connection to tach wire (-).
If connection to an alternator is required, connect to 12V when the engine is running
and 0V when the engine is stopped.
ENSURE system is programmed / set accordingly.
4. Jumper selection
Jumper function
ON
OFF
1
first cranking time
* 0.75 sec.
1.5 sec.
2
engine running detection
* from tach
from alternator
Note:
* Factory default setting.
* Ensure power is removed from the module before removing or installing Jumpers
5. Do not try to remote start until the following steps have been checked.
Turn the ignition switch to ON (do not start the engine).
Open the door and check that the LED is OFF.
Start the engine with ignition key in the normal manner.
Close the door and check that the LED is OFF.
Open the door and check that the LED is flashing.
07-08-356-2
