24 hour protection …every day
Congratulations on the purchase of your PROTECTOR EL-1
anti-theft safe with electronic keypad.
MANUAL
First, read the manual carefully before you start using the safe.
TO OPEN THE SAFE
To open the door of the safe for the first time: Press
1
,
5
,
9
, and
B
. While you are pressing the numbers the top yellow light on
the keypad will display. After pressing
B
he green light will
come on. Now turn the knob to the right and open the door.
TO CLOSE THE SAFE
Close the door and turn the knob to the left. The door will
now be locked.
TO PROGRAM THE DIGITAL COMBINATION LOCK
1.
Press the red button on the inside of the door near the
hinges; then release it and you will hear two beeps and the
yellow lamp will light up.
2.
Now press from 3 to 8 numbers that you wish to use as a
combination, and confirm by pressing the letter
B
. Be sure
to write them down immediately, so you don't forget how to
open the safe.
3.
Check if you have entered the correct combination a couple
of times –
with the door open
– by pressing the numbers
you have chosen followed by
B
. If you have entered the
correct combination, first the yellow, then the green light
will come on. Then you can turn the knob to the right and
the door will open.
4.
If the procedure operates without any problems you can
close the door and turn the knob to the left, after 5 seconds
the electronic closing-mechanism will lock.
5.
To open the safe follow the procedure as described in point
3.
6.
If the incorrect code is used, the door will not open. You
must now wait 20 seconds to try again. If the wrong code is
used again, you must wait over 5 minutes to try again. More
incorrect codes will freeze the system for one (1) hour. (See
override key instructions).
7.
After entering your correct personal combination, you have
5 seconds to turn the knob before the mechanism relocks. If
it relocks, enter your combination again.
TO CHANGE TE BATTERIES
Open the door, move the lid of the battery holder, that is on the
back of the door, up. And place 4 pieces
1,5V AA SIZE
ALKALINE
batteries in the holder. Put the lid back in place.
BATTERY REPLACEMENT WARNING
If the batteries are low, a red light (in the middle) will warn you
immediately. To test the batteries, enter your code to open the
door. When the batteries are low the red light will light up. When
this does not occur, the batteries are fine. When the red light
flashes you should change the batteries immediately. Failure to
do so could result in you not being able to open the safe without
resorting to the use of the override key.
OVERRIDE INSTRUCTIONS TO OPEN THE SAFE
For your convenience, we have engineered a manual override
system into your Protector EL-1. If you forget or misplace your
combination, remove the small plate in the middle of the lock.
Behind this you will find a keyhole. The key delivered with you
safe will fit this keyhole. Insert the key and turn it to the left in a
counter-clockwise direction. Turn also the knob in a clockwise
direction toward the right. This will manually open your safe at
any time.
Do not keep the key in the safe. In the event of battery failure
you will not be able to open the safe.
Summary of Contents for EL-1
Page 2: ......
