background image

Made in China

V1.0

Conforms to safety requirements of FCC. 

©2016 Rooftop Brands™    All rights reserved 

Tel: + (1) 949-566-9573  •  www.propelrc.com

 

15

WARNING: Never leave product charging unattended for extended periods of

time. Always disconnect the battery from charger immediately after the battery

is fully charged. Please refer to enclosed safety instructions.

INSTRUCTION BOOKLET

PACKAGE CONTAINS:

Colors and styles may slightly vary.

FCC Part 15 C Notice

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
•    Reorient or relocate the receiving antenna.
•    Increase the separation between the equipment and receiver.
•    Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•    Consult the dealer or experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : 
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause 
    undesired operation.

2.4G Wireless

 Controller

Instruction 

Manual

Spare Parts

USB Card Reader

& Micro SD Card

Spyder XL™

SPYDER XL

Hybrid Stunt Drone with HD camera and 

Altitude Stabilization Technology

PROPEL

AC Charger 

&  Li-Poly 

Rechargeable Battery

CHOKING HAZARD - Small parts. 

Not suitable for children under 3 years.

WARNING!

WEEE Directive & Product Disposal
At the end of its serviceable life, this product should not be treated as household or 
general waste. It should be handed over to the applicable collection point for the 
recycling of electrical and electronics equipment, or returned to the supplier for disposal.
Internal/Supplied Batteries
This symbol on the battery indicates that the battery is to be collected separately. This 
battery is designed for separate collection at an appropriate collection point.

ON BOARD

HD VIDEO

ON BOARD

HD CAMERA

1280 x 720 pixel 

30 frames per second

INDUSTRY CANADA NOTICE: CANADA ONLY.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this 
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired 
operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est 
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter 
dout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

BC

Summary of Contents for Spyder XL









Reviews: