Operating Instructions & Parts Manual
Scissors Jack
To avoid crushing and related injuries:
NEVER work under a load supported
only by a jack. ALWAYS use adequately
rated jack stands.
WARNING
!
ATENCIÓN
• Leer, comprender, y seguir las
instrucciónes antes de utilizar el
aparato.
• El manual de instrucciónes y la
información de seguridad deben estar
comunicado en lengua del operador
antes del uso.
• No seguir estas indicaciónes puede
causar daños personales o materiales.
!
Printed in China
OIPM# SSJ-03
Model Number
T-9446
Capacity
3300 lb
Shinn Fu Company of America, Inc. © 2003
10939 N. Pomona Ave.
Kansas City, MO 64153
Phone (816)891-6390, fax (816)891-6599
90 DAYS LIMITED WARRANTY
For a period of ninety (90) days from date of purchase, Shinn Fu Co. of America,
Inc. will repair or replace, at its option, without charge, any of its products which fails due
to a defect in material or workmanship, or which fails to conform to any implied warranty
not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning
the warranted product, freight prepaid, to Shinn Fu Co. of America, Inc. Warranty Service
Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specifically prohibited by
applicable law, (1) the CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE
REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS AS DESCRIBED ABOVE,
and (2) Shinn Fu Co. of America, Inc. SHALL NOT BE LIABLE FOR ANY
CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE
DURATION OF ANY AND ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING
WITHOUT LIMITATION, ANY WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE, IS LIMITED TO A PERIOD OF NINETY (90) DAYS FROM
DATE OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
OPERATION
Lifting
1. Place vehicle in park, with emergency
brake on and the wheel diagonally op-
posite from the wheel being lifted
chocked in both directions.
2. Insert the handle into the hole of the
handle socket. Center the saddle un-
der lift point. Jack shall be positioned
at 90 degrees perpendicular to the ve-
hicle frame seam.
3. Hold the front portion of the handle shaft
with one hand, and use the other hand
to crank the upright portion of the handle
clockwise.
4. Continue to crank it until you reach the
desired height, but never beyond a point
just high enough to remove and install
the tire.
Lowering
1. Crank the upright portion of the handle
counterclockwise.
2. After removing jack from under the load,
push saddle down to reduce ram ex-
posure to rust and contamination.
MAINTENANCE
Lubrication
Lubricate the thread and bearing with
wheel bearing grease. A periodic coating
of light lubricating oil to pivot points, axles
and hinges will help to prevent rust and
assure parts move freely.
Note: Never apply lubricant directly on top
of saddle.
Cleaning
Periodically check the jack for signs of rush
or corrosion. Clean as needed and wipe
with an oily cloth.
Note: Never use sandpaper or abrasive
material on these surfaces !
Storage
When not in use, store the jack with sad-
dle fully lowered.
4
