E-1
WARNING
To prevent this unit from malfunctioning :
• Do not strike the PS-G's touch panel with a hard or heavy object, or press on the
touch panel with excessive force, since it may damage the display.
• Do not install the PS-G where the temperature will exceed its specified range.
• Be sure that water, liquids or metal particles do not enter the PS-G, since it may
cause a malfunction or a short circuit.
• Avoid installing the PS-G where sudden, large changes in temperature may occur.
These changes may cause condensation to form inside the unit, possibly causing a
malfunction.
• To prevent excessive heat from building up inside the PS-G, do not install it where
its ventilation holes may be blocked. Also, do not install or store the PS-G near high
temperature equipment.
• Do not install or store the PS-G in direct sunlight or where high levels of dust exist.
• Since the PS-G is a precision instrument, do not install or store it where either strong
shocks or excessive vibration may occur.
• Do not install or store the PS-G in an area containing chemicals or chemical fumes.
• Do not use paint thinner or organic solvents to clean the PS-G's case or screen.
• Due to the danger of unforeseeable accidents, back up all PS-G data regularly.
• After turning this unit OFF, be sure to wait a few seconds before turning it ON again.
If the unit is started too soon, it may not start up correctly.
• When connecting the PS-600G (hereafter referred to as the "PS-G")'s power cord
terminals to the PS-G's Terminal Block, check first that the PS-G's power supply is
completely turned OFF, via a breaker, or similar unit.
• Whenever changing the Backlight, to prevent electric shocks and burns, be sure to
turn OFF the PS-G's power and wear protective gloves.
• Do not open or remodel the PS-G unit, since it may lead to a fire or electric shock.
• Do not use power beyond the PS-G's specified voltage range. Doing so may
cause a fire or an electric shock.
• Do not use the PS-G in an environment where flammable gases are present, since
operating the PS-G may cause an explosion.
• The PS-G uses a lithium battery for backing up its internal clock data. If the battery
is incorrectly replaced (i.e. its + and - sides are reversed), the battery may ex-
plode. When changing the battery, please contact your local PS-G distributor.
• Do not use the PS-G unit as a warning device for critical alarms that can cause
serious operator injury, machine damage or production stoppage. Critical alarm
indicators and their control/activator units must be designed using stand-alone
hardware and/or mechanical interlocks.
• Do not use PS-G touch panel switches in life-related or important disaster prevention
situations. For safety related switches, such as an emergency switch, be sure to use
a separate mechanical switch.
• To prevent operator injury or machine damage, be sure to design your machine
operation system so that the machine will not malfunction due to a communication
fault between the PS-G and its host controller.
• The PS-G is not appropriate for use with aircraft control devices, aerospace equip-
ment, central trunk data transmission (communication) devices, nuclear power
control devices, or medical life support equipment, due to these devices inherent
requirements of extremely high levels of safety and reliability.
• When using the PS-G with transportation vehicles (trains, cars and ships), disas-
ter and crime prevention devices, various types of safety equipment, non-life sup-
port related medical devices, etc. redundant and/or failsafe system designs should
be used to ensure the proper degree of reliability and safety.
WARNINGS
