ENGLISH
Battery Installation - See Figure 1
3 AAA Alkaline
Princeton Tec cares about the environment
and recommends recycling batteries. For
more information about battery recycling,
please go to www.batteryrecycling.com.
Observe proper battery polarity. Improper
installation of the batteries will damage the
light and void the warranty.
WARNING
C
• Never mix fresh and used batteries.
• Never mix different battery brands
• Always remove drained batteries
• Remove batteries during
storage
long periods of
The Vizz battery compartment has a wa-
terproof seal. It is important to keep this
seal free from dirt and away from harsh
chemicals in order to preserve waterproof
integrity. Inspect the seal every time batteries
are changed. If dirt is present, wipe gently
with a damp cotton swab and mild soap until
dirt is removed.
Switch Operation - See Figure 2
A single press turns on Maxbright (spot)
mode. Ultrabright
mode is selected
by holding button. Ultrabright mode starts at
the highest
intensity
level;
intensity
decreases until button is released. If button
is held down continuously, light intensity will
scroll down and back up until button is re-
leased. If another brightness is desired after
button has been released, holding button will
resume scrolling through Ultrabright LED
intensity levels.
A single press more than two seconds after the
previous button press will turn the light off.
Troubleshooting
If the Vizz fails to light:
•
Check
the
batteries
for proper installation.
•
Replace batteries if proper installation is
•
Check circuit board for water (the seal may
have been compromised by improper rear
cover installation or dirty seal). The light will
resume normal operation once the water
is shaken or blown out and the light is left
open until completely dry. If the light has
been contaminated with salt water,
the
unit
with
fresh water and dry as
described above.
USA Lifetime Warranty - International
10-Year Warranty
Due to International regulations, Princeton
Tec’s lifetime warranty can only be offered to
customers in the USA. Princeton Tec offers a
10-year warranty to our customers outside
the USA.
FULL WARRANTY - PrincetonTec
warrants this product to be free from defects
in workmanship and materials under normal
use for as long as you own this product.This
warranty covers all of the component parts
of the product except batteries. This warranty
does not cover deterioration due to normal
wear or damage due to misuse, alteration,
negligence, accidents, or unauthorized repair.
Princeton Tec will repair or replace parts which
are defective in workmanship or materials.
Your authorized Princeton Tec Dealer and
Princeton Tec are the only facilities authorized
to repair the product. After (3) unsuccessful
attempts to repair the product, you have the
right to elect replacement of the product or a
refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARE INCLUDED
IN THIS WARRANTY. (Some states do not al-
low the exclusion or limitation of incidental or
consequential damages, so the above limita-
tions or exclusions may not apply to you.)
This warranty gives you
legal rights,
and you may also have other rights which
vary from state to state.
Princeton Tec reserves the right to change
product
without notice.
Return Policy
Figure 2 – Switch Operation
Modes de fonctionnement
Schalterbetätigung
MAXBRIGHT LED
ULTRABRIGHT WHITE
DIMMABLE LEDs
•
Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of
0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
•
Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale
Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-
tungsstärke des Vollmonds in einer klaren Nacht.
•
Princeton Tec
la durée totale d’éclairage comme le temps nécessaire à la source
lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la
luminosité d’une pleine lune dans un ciel nocturne dégagé.
Figure 1 – Battery Replacement
Remplacement des piles
Batteriewechsel
1
2
3
4
www.princetontec.com
SINGLE PRESS
MAXBRIGHT LED
SINGLE PRESS
TURNS LIGHT OFF
HOLD
WHITE ULTRABRIGHT
(HIGH) (LOW)
Intrinsically Safe Apparatus
Princeton Tec Vizz for use in hazardous locations
only as to intrinsic safety class I, II, III; Division 1&2;
Groups A-G; T4; -20°C < 40°C. Warning- substitution
of components may impair safety. Change batteries
in an area known to be non-hazardous. Do not mix
new batteries with used, do not mix
batteries from different manufacturers. Use with
three AAA batteries, Duracell: MN2400
VIZZ
TM
II
INTRINSICALLY SAFE
LED
HEADLAM
P
0317
Use with three AAA batteries,
Duracell: MN2400
meters
36
70
UL 913 ISSUE:2006/07/31 ED:7 REV: 2011/09/23 UL
CAN/CSA C22.2#157
ISSUED:1992/06/01 ED:3 (R2012)
Conforms to UL 913 Eighth Edition, Dated
December 6, 2013. Certified to
CAN/CSA-C22.2 No. 157-92 June 2003.
Princeton Tec
PO Box 8057
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
®2017 Princeton Tec
If your light fails to operate, follow these
simple steps:
1) Check batteries. Replace if necessary.
2) To send your light in for repair or replace-
ment, first contact Princeton Tec customer
service on 1-800-257-9080 to request an RMA
number. Please have your light model, date of
purchase and a brief description of the fault
you are experiencing. No warranty repairs will
be accepted without an RMA number.
3) Return the light without batteries to:
Princeton Tec, PO Box 8057 Trenton NJ 08650
Postage due and freight collect items will not
be accepted.
4) Upon receipt your light will be processed in
about two weeks. Please allow additional time
for return transportation from New Jersey
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol
A (BpA) a chemical known to the State of
California to cause birth defects or other
reproductive harm.
