Troubleshooting
As with any equipment, the Sector 5 should be rinsed with
fresh water after any contact with salt water. Move the
switch and switch lock back and forth a few times while
rinsing with water to prevent salt build-up.
Flooding
In the unlikely event your light leaks or is flooded,
immediately remove the batteries. Flush all parts with fresh
water and allow to dry. Check for possible cause of leakage
and correct problem; return light for repair if necessary. Do
not reuse batteries that have been wet. Batteries from a
flooded light should be discarded.
Troubleshooting
If the Sector 5 fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed
USA– International 5-Year Warranty
WARRANTY – Princeton Tec warrants this product to be free
from defects in workmanship and materials under normal
use for 5 years. This warranty covers all of the component
parts of the product except batteries. This warranty does not
cover deterioration due to normal wear or damage due to
misuse, alteration, negligence, accidents, or unauthorized
repair. Princeton Tec will repair or replace parts which are
defective in workmanship or materials.
Your authorized Princeton Tec Dealer and Princeton Tec are
the only facilities authorized to repair the product. After (3)
unsuccessful attempts (within the warranty period) to repair
the product, you have the right to elect replacement of the
product or a refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR CONSEQUENTIAL
DAMAGES ARE INCLUDED IN THIS WARRANTY. (Some
states do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitations or
exclusions may not apply to you.) This warranty gives you
specific legal rights, and you may also have other rights
which vary from state to state.
Princeton Tec reserves the right to change product
specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING:
This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first
contact Princeton Tec customer service on
1-800-257-9080
to request an RMA number. Please
have your light model, date of purchase and a brief
description of the fault you are experiencing. No
warranty repairs will be accepted without an RMA
number.
3. Return the light without batteries to:
Princeton Tec, PO
Box 8057 Trenton NJ 08650.
Postage due and freight
collect items will not be accepted.
4. Upon receipt your light will be processed in about
two weeks. Please allow additional time for return
transportation from NJ.
ENGLISH:
Battery Installation
Princeton Tec cares about the environment and recommends
recycling batteries. For more information about battery
recycling, please go to: www.batteryrecycling.com.
Observe proper battery polarity when installing the batteries.
Improper installation of the batteries will damage the light
and void the warranty.
WARNING
!
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
NOTE: Some battery formulations can emit hydrogen gas.
This gas can create an explosion potential in sealed devices
if not vented or removed. The Sector 5 is equipped with a
platinum catalyst that will remove this gas. When replacing
the batteries, visually inspect the LED module for broken or
missing catalyst. If the catalyst appears to be damaged, (you
may notice gray particles in the battery compartment), or the
light has flooded, replace the catalyst before using.
Switch Operation
– See Figure 2
ON/OFF
With the light off, a single pull of the trigger switch will
activate
HIGH
output.
Brightness Adjustment
From HIGH, pull the trigger switch twice to activate
LOW
.
A single pull from LOW willl re-activate activate
HIGH
After 3 seconds in any mode, a single pull of the trigger
switch will turn the Sector 5
OFF
Momentary ON
From OFF pull the trigger switch halfway in to activate
Momentary On.
Release the trigger switch to turn
OFF
O-Ring
• Occasionally clean and lightly lubricate the O-Ring and
lens cap threads. Use only silicone grease, never use
aerosol spray lubricants.
• Clean the contacts of your light periodically
WARNING
!
• All plastic components are made of high-impact resistant
polycarbonate plastic. Certain forms of aerosol sprays can
cause damage and void warranty.
• To avoid water leakage, do not over tighten the lens cap.
Figure 1 – Battery Replacement
Figure 2 – Switch Operation
UNLOCKED
LOCKED
Pull 1x:
On / High
After 3 Seconds
Pull 1x from On:
Off
From High
Quickly pull 2x:
Low
From Off
Half Pull 1x
(no click)
:
Momentary On / High
Standard operation:
Figure 3 – Performance
Modes
Lumens Runtime
Beam Pattern
Reserve
HIGH
1200
6h
1h
LOW
200
13h
1h
DISTANCE (m)
0
100
230
(ANSI FL-1 Standard)
Runtime
is defined as the duration of time from the initial light output value—defined as 30 seconds after the
point the device is first turned on—using fresh batteries, until the light output reaches 10% of the initial value.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2022 Princeton Tec
2
3
1
Operating and Maintenance Instructions
SECTOR
®
5
LED SPOTLIGHT
